Search:

Type: Posts; User: alexk

Search: Search took 0.22 seconds.

  1. Replies
    6
    Views
    2,490

    There we go. What I had to do was take a 3/8th...

    There we go. What I had to do was take a 3/8th extension and come in diagonally behind the chain, then tap that with a hammer while pushing in on the shoe.

    For posterity... i basically tapped the...
  2. Replies
    6
    Views
    2,490

    The manual states: Primary Chain Adjuster 1....

    The manual states:

    Primary Chain Adjuster
    1. See Figure 6-3. If shoe is badly worn, replace it.
    2. Install chain tensioner spring into shoe.
    3. Slide shoe onto pin.
    4. Tilt shoe upward until...
  3. Replies
    6
    Views
    2,490

    Wiggling doesn't seem to help - I think there's...

    Wiggling doesn't seem to help - I think there's an alignment issue with the chain tensioner. It doesn't line up with the chain quite right, but its inserted all the way onto the spring.

    Pushing...
  4. Replies
    6
    Views
    2,490

    Well, I've finally managed to put together some...

    Well, I've finally managed to put together some time to reassemble after my transmission issues. Man, am I looking forward to blasting again.

    I'm down to putting the primary cover back on (the...
  5. Thread: Height issue?

    by alexk
    Replies
    17
    Views
    34,369

    6'5" 225lbs here on the normal (high) seat. Yes,...

    6'5" 225lbs here on the normal (high) seat. Yes, I look ridiculous on the bike, but it fits me pretty well.

    The only issue I really have fitwise is body parts going numb on rides. I find that if...
  6. Replies
    21
    Views
    24,994

    Not sure why it won't let me edit that post,...

    Not sure why it won't let me edit that post, but...

    1) It is forward threaded. Push the bike backwards while lifting the cheater bar. It gently eased off rather than breaking away =)

    Still...
  7. Replies
    21
    Views
    24,994

    Couple questions if you don't mind. 1) Is the...

    Couple questions if you don't mind.

    1) Is the engine sprocket nut reverse or forward threaded? Can't seem to get it to come loose, and I'm to the point I'm concerned adding additional pressure...
Results 1 to 7 of 7