Search:

right ive done a voltage check on tps ,
im getting 0.16 v dc closed throttle
im getting 0.79 v dc fully open throttle,
is this the standerd voltage as the sensor is fixed .
still carnt conect to...

just a thought can i set the tps if i know the right voltage or ohm's any info on this ,yes you guessed it i still havent been able to get it to work DO'H .

Thanks jimi ive been on this for 3 night's after work im at that stage where ive had to lock the sledg hammer away,some 1 also told me that the nak error also shows that pc has the right com port and...

right i think im getting somewhere lol run a few more updates set as admin ecmspy now reads open when program opens were as befor it always read closed will try it on xb tomorrow will update post...

HI THANKS for info all drivers are up to date no yellow triangle.

ive been pluging usb cable into pc 1st,then into xb9r,then ignition on wate kill switch to run ,then run ecmspy ,i then klick...

ecm spy com port is there device manager says all ok but ecmspy says recived error got NAK any help please running prog on win 7 on a xb9r 2002 .

my tps needs a reset but wont find com port on windows 7 should i use win xp just tryed it again it finds com port but still wont run ,closed loop dose not turn to green when port (com6)detected?.

thanks will look i bet its not far of the xlh set up .
will update on progress as soon as i have chance .
i used to chainge the xlh every 4 months .

thanks will give it ago ,ref primary can i use sportrans fluid (as i have 2 quarts )left over from me xlh1200 4 speed,or in the buell do i use synthetic 20w/50 V-Twin motor oil?.in primary on a xb9r...

i might be a bit vane in my explanation when i gave her a run i went through the gears takin rpm to 6000-6800 rpm between gear change (was goin some) pulled clutch in to change up rev's slow to drop...

xb9r 02 runing rough.
push rod o rings ok (no leak) but took her for a run yesterday and not good .
1st, started ok idle ok at 1st i was in 4 gear at about 2000-2500rpm doin about 40mph throtle...

xb9r 02 runing rough.
push rod o rings ok (no leak) but took her for a run yesterday and not good .
1st, started ok idle ok at 1st i was in 4 gear at about 2000-2500rpm doin about 40mph throtle...

http://www.zippersperformance.com/catalogue/showproduct.asp?cat=814&prod=1904

Hi all the web site above dose custom pushrod covers
no more engine turn no need to strip top rocker ,done my o ring...

thanks for info found it engine turn pic's supper

hi thanks for info looks like engine out again then had to put new gear selector rods in & new spring on neutral selector arm ,only had xb9 3 months but its better than the harley but a lot harder to...

and its got worse oil all over me foot so bike now of road ,i know the head has to come off to do this ,can the engine mounts be took out but leave the swingarm mount in and swing engine down to get...