Search:

Type: Posts; User: zanzibar

Search: Search took 0.06 seconds.

  1. Replies
    36
    Views
    33,154

    My answer is YOU! CuCuter stop to put your...

    My answer is YOU!

    CuCuter stop to put your **** on Buell. Stop now, one can be bad with people, but must gain the right with a superior knowledge to share. You are very short of that.
  2. Replies
    36
    Views
    33,154

    My talk are general consideration and will assume...

    My talk are general consideration and will assume that bikes are fully sound.
    If so, it can be perhaps possible solve a stability issue, by forum, otherwise not.
    As you write here it's supposed you...
  3. Replies
    16
    Views
    13,001

    :up::up: Fully agree and Very well explained,...

    :up::up: Fully agree and Very well explained, Thank you.
    Just right side bearing outer race is supposed to get very close to the "floor" but not fully bottom it.
    Right side Inner race must bottom...
  4. Replies
    16
    Views
    13,001

    I spent a live as mech. technician, just...

    I spent a live as mech. technician, just discovered this forum, not enough to understand your quote.
    But enough to understand you are so full of gas that you fart more with your mouth than your...
  5. Replies
    16
    Views
    13,001

    Hi Marius, for as low as 65 bucks I would sure...

    Hi Marius,

    for as low as 65 bucks I would sure change it and keep mine as spare.
    As far as you sure to get a good one and right for your bike.
    Standoff is just the place where left inner race...
  6. Replies
    16
    Views
    13,001

    Marius, my opinion is different, so is better...

    Marius,

    my opinion is different, so is better you get a third one, and you choose for yourself.
    As far as the swing arm damage is what can be seen on your pic, I would not change it. (is that...
  7. Replies
    7
    Views
    5,109

    Hey AC_Schnitzel, first of all get workshop...

    Hey AC_Schnitzel,

    first of all get workshop manual for your model and read it.
    No reason to repeat here what has already written there.
    Anyway piston of the head side you are removing need to...
Results 1 to 7 of 7