Oh well, i had to do most things myself, it's always not easy. I don't want the same mistake happen twice. I still have my xb9sx i use as parts swap.
Type: Posts; User: samuelseggs
Oh well, i had to do most things myself, it's always not easy. I don't want the same mistake happen twice. I still have my xb9sx i use as parts swap.
Thank you njloco, I just read about this in the manual, Phew i'm looking for the tool to do this.
Thank you for your previous response. I must apologize for the mistake I made in my previous message. I actually use 20w50 Motul Oil for my 09 xb9sx. Unfortunately, my motorcycle sustained damage...
Thank you Cooter,
We only have less than 5 Buell in my state/country and I own 2. We don't have any mechanics who understands the bike. The other bike got totalled because I trusted a mechanic wth...
I've been experiencing a persistent issue with my bike, and it's been quite a journey trying to diagnose and fix it. The main problem arises when I ride for around 30 minutes – the bike starts...
I have this same problem. It started happening after I wrapped up my exhaust. When I read for codes. I can see any.
Is the exhaust available?
Apologies for delayed response. While checking through other threads on Badweb most people confirmed that i need to change the CPS. I got one off eBay, it took a while to reach me... Missing item......
This is going to be my second buell. I lost hope taking the buell into the Auto Store for fix as they make very poor decision and i mostly have to go back with problem worse or some new problem.
I...
Today I got a Buelltooth device.. Hooked it up and got error 11 TPS too low/short to Ground.
I also checked AFV and it was reading 115% so I reset back to 100%. I tried doing a live test. By...
Here is a video of the bike
https://youtu.be/NSr7SbtIjV0
Any idea how this is done for this bike.
I just got an 06' ulysses buell, less than 40k mileage.
Initially I noticed that the RPM gauge works only when you twist the handle to the left. I cleaned out the ground wires under the headlamp....
I have cleaned out the grounds at the steering neck but still not working perfectly. I will have to read through the manuals
I have a 2006 Ulysses. I can't seem to get a 12v/12ah battery. Can I use a 12v/14ah battery as replacement.
Thank you very much. I noticed if I turn the handle to the left... The gauge works again. Could it be a loose wire at the handle bar?
Hello,
Good day. I have an 06 Xb12 Ulysses.
Today I noticed that the RPM does not read. When I switch key position to on. I get the early sweep. Both RPM and Speedo sweeps to the right. However...
I was able to take a reading of the stator and it shows 65v-120v when i rev and 35v when idle, is this normal? SHould i change stator also. i don't want to buy another VR and it goes bad again.
I'm in Nigeria, yes postal service sucks and first class air packages gets lost.
John can I also test the stator to be sure it's in good state..
I thank you.
Thank you very much.. That video was helpful..
Here is a video
https://youtu.be/cleYUQrxQls
Okay I went to the store and got this.. Please how do I use.. 12734
I have been able to put the new gaskets on my bike. But i now face a whole new set of issues
Here is what i did.
1. I changed the front block gasket only, since the rear block had no leaks
2. I...
12731 here is the reading from my buelltooth
My bike was cutting fuse. I found out the Voltage Regulator was bad. I had an old one from my ducati(scrapped) luckily it was same match.
After a 2 day ride.. My CEL came on. I checked with the...
Thanks John, I'll look into these and give you feedback, are there any other thing to look into since I'm going to rotate the engine.?