Let us know how it goes. Check your pm.
Type: Posts; User: Camp762
Let us know how it goes. Check your pm.
I've three eeprom s that I have found in the last three months. My '06 has an '07 air box so I flashed my ecm to '07 eeprom. I've also modified the '07 to a "summer logic" with fan on around 30°...
Yeah, I'm just jgetting prepared, it will be near 100° soon but we have lots of humidity here. This is my good weather bike and I drive a concours 1000 in the winter, I just was wanting to have a...
Upper eighties, two up riding was getting warm and thought I heard a little pinging. I've been going over this thing for a few months since I got it, can't think of anything that jumps out at me. ...
My bike got hot enough yesterday I thought I heard pinging with new royal purple oil and running 93 octane gas the bike seems like its a tad hot, I'm familiar with oil cooled, drove my first 50K...
Greetings,
I was curious if the fan logic changes had any adverse effects since trying this modification. I'm looking to do the same for my '06 xb12x Ulysses that uses the same ecm as your bike...
I would agree with lunatic and try adding the ground wire from the coil to the negative battery terminal. My 06 was having the same issues and after re-mapping and checking multiple suspects to no...
7309
I've got the low seat and the PO wrapped the ecm which the seat still clears. I'd like the bar risers to allow me to drop the front forks an inch in conjunction with a lower rear...
OK, thanks to all those who have given advise throughout my ordeal here. I've discovered when chasing the threads from the left I ended up pushing a loose piece of thread metal into the start of the...
Sounds close, I've done this about eight times previously on my other bikes, all have been on their center stand, this is the first time I had to use a motorcycle jack. The tire was only lifted...
Pretty sure on those bearings, all balls brand. Thanks for the offer, I'd like to take care of this without the expensive replacement parts. I'm off for a week starting tomorrow, was really...
Looked at and tried all of the above, the lip clears the swing arm and the strap torqued over the axle seemed a no go as well. Just in case, if anyone can source a used swing arm on the cheap, I may...
My fuel pump is fixed up and slid in smooth, the constant running has quit, as long as the new orings didn't pinch that's covered, I'll see when I gas up again. The axle lip did catch my attention...
I am the one you saw Saturday, I'm South of the River in Ashland City.
I tried threading from the other side and the threads aren't buggered. I'd hate to do the 10' bar route, but if there is a...
Long story short, first tire change after strange tire wear on new to me '06 Ulysses, corroded axle pulled the crushed/shot drive side bearing out of wheel and stretched apart swing arm instead of...
I'm interested in the fly screen please. Pm sent.
Let me in on the junk pricing on the driving lights, if I may be able to afford at a poor mans budget. Thanks.