Release fuel line pressure according service manual, disconnect fuel line from the intake fuel ramp, guide the fuel line in the canister, connect fuel pump back, turn ignition key on and start the...
Type: Posts; User: X B
Release fuel line pressure according service manual, disconnect fuel line from the intake fuel ramp, guide the fuel line in the canister, connect fuel pump back, turn ignition key on and start the...
https://www.youtube.com/watch?v=SZk_aW6ppoM
Go to local Home Depot and buy a 1/4-20 x 1.5" long bolt, a washer, a piece of thick aluminum bar, some tape and make your own tool
https://i.ibb.co/V29WDsG/IMAG1927.jpg
1/4-20 - same as the fuel pump mounting screws.
You also need 2 seals for inline fuel pump filter - replacement for part number P0164.K is piece of gasoline resistant petroleum hose 5/16" ID x 9/16" OD x 5/8" long, Buna-N - 0.07$ per each vs 7$...
If you are planning to change fuel pump pressure regulator it will likely go with new o-rings. If you are planning to reuse the fuel pump pressure regulator you will need two different sizes o-rings....
You also need 2 different sizes o-rings for fuel line banjo fitting - replacement for kit part number P0198.02A8:
1 o-ring dash number 010, Viton, 1/4" ID x 3/8" OD x 1/16" CS, Durometer 75A -...
Correct thickness is 3/32" (not 3/16") http://www.badweatherbikers.com/buell/messages/3842/772831.html?1459726014
Dash number 151, Viton, 3" ID 3-3/16" OD 3/32" CS, Durometer 75A
1$ each on...