So much fail here by those who spout, yet have no knowledge of what really happened.
If, as some have said, the Engineering design side was being used to pay for the bike side until it got...
Type: Posts; User: poppinsexz
So much fail here by those who spout, yet have no knowledge of what really happened.
If, as some have said, the Engineering design side was being used to pay for the bike side until it got...
I believe the pistons pin sits lower in the 12 stuff. This will cause low compression problems.
I could be backwards on that and they sit higher.
How can you tell you were the only owner?
Here once a title is issued only the current owner and any leinholders are listed on the title.
when I buy a used vehicle from someone I take the title to...
The XBrr had a 1339 engine, and It would have had a chain drive and i doubt street legal.
I've had both at the same time, an 08 1125R and an 07 12R.
Like everyone else said there is a big power difference, but really its more that the power comes in later and lasts longer. Where I can...
What about putting a fitting in the drain plug and running the tube up to the fill cap? on the outside of the frame of course.
Save drilling into the swingarm.
Try buellsterparts they used to have them
If it were me, I'd prob razer along the length to get the nail out and spread it apart to see what damage is on the bottom. Then make a call on replacement. As from the picture it doesn't appear to...
Most likely you need to adjust your primary chain. It will effect shifting and finding N.
Look under the service manual link at the top of the main forum page.
There are some in there. May not be for your bike but most of the xb series stuff is the same so it should do for what you want.
Be careful with the S100!!!!!!!
It will stain the powder coated parts if left on to long.
It does work great but I have a bolt that now has some stains that look like darker paint runs where I...
You can get some of the parts like the frame rails here http://www.buellsterparts.com/
I love to read some of the stupid.
As for the RR driver, mistake 1- getting off open road.
mistake 2- not using reverse once having been stopped.
As for squids/punks- to much stupid to count. ...
I think mine is getting ready to die. It tends to get stuck at different temperatures.
A while back I saw a thread where someone made a list of different cars that used the same one. I can't seem...
Didn't the 08 models have some fuel efficiency issues?
and was that ever fixed?
Kickstart my heart, Motley Crew-although this one can cause me to get in trouble
Dreams, Van Halen
Shoot to Thrill,AC/DC
I believe that is the port where the California emissions canister would hook to.
Like others said be sure to cap it off.
Different Craig jones
I think it is on a time basis, however I am not sure.
It is the fuel pump, it keeps the system pressurized to prevent vapor lock in the fuel system
poppinsexz #1
Charleston WV, There is only the one.
I took my 1125r to the local dealer last fall for the water pump weep(my warranty was running out).
Long story short Tech bent the radiator bottom tank where the water pump inlet tube attaches. It...
It will always change tension due to normal wear. Usually they get loose over time, but heat causes everything to expand which could cause it to tighten when running.
If it truely won't go into N(as in not an electrical problem) you may check and/or adjust the primary chain tension. This will effect finding N when hot and running.