How much do wheels go for? I'm thinking I might take on a project this summer.
Type: Posts; User: cb750
How much do wheels go for? I'm thinking I might take on a project this summer.
You can always run down 28 and stay at the Kickstand Lodge, they will rent you a tent, or a small cabin. Small meaning its just big enough for a queen size bed and some room to change clothes.
I've...
That yellow...
My orange airbox cover is cracked at the mounting holes, but 500 bones is a bit steep for me.
I registered on some Buell board years before I actually bought one. I don't remember what the forum name was, I just remember "Socially Unacceptable" on the banner.
Is there a way to search...
I've got similar ones, and the lenses have been falling off. I glued two back on, but a third one is gone in the wind somewhere.
Its about 30* degrees and I'm preparing to ride to work today. As I've gotten older I've stopped riding in cold temps, just because I don't like having to gear up so much to stay warm.
This is what happens when I don't check in regularly, I miss the good stuff. My old one quit working after becoming beer soaked at Dragon VI. Been interested in another, just not for the $90 I paid...
I just put Pilot Road 4s on. They are made in Spain too. I've only got a half mile on them because it has been raining here.
The only advice I would offer is to lean the bike against something, if you have an engine hoist or can attach straps to something overhead and lean it way over, then you don't have to drain the...
I'm Indiana and plan to head out on the 21st. I'll be there sometime monday afternoon/evening. I'll probably just throw a tent up at the resort if I can find it. Hopefully I can get a spot near a...
There was a tuner on the bike when I bought it, but I took it off. I do have LED turn signals and license plate lights, but that's it.
Got the NGK iridiums on order, they should be here Saturday....
Is your primary tensioned correctly?
this has been going on for years. When I start the bike and it's cold, (cold motor, not weather) it runs for a few seconds, runs rough, and dies. Usually I start it again, rev it some, and it runs...
Years ago I was driving ten miles on a fairly busy wo lane to work and back. I noticed than when I was in my car everyone seemed to drive slow, and when I was on the bike everyone seemed to drive...
That's pretty awesome of him
In other words, the "valve cover" on the rear head is the one that usually goes. If it gets bad it'll short out the fan. It's hard to describe, I'll get a pic up this evening if no one else does.
Lexan?
I talked with a coworker about doing an IB a year or so ago. I'm up for it if it's on one of my days off. I doubt I would do it on my XB, more likely on my HD, unless the Corbin that is on it's way...
If you look close at the base of your cylinders there is a HD logo.
I love dem old fridges. Most of my friends have old ones for beer fridges in their garages. I've got a Kelvinator I am trading for an IH fridge. The old ones have style the new ones just don't have,...
I don't do it, but I have been looking into upgrades for the k341 I am rebuilding in my Cub Cadet. One thing that is holding me back from putting the motor together is I either need a new lifter or...
I've got three ecms here that all have different firmware, I can't remember which which one is the '08, but I've used all three of them. I don't think firmware is that important.
I think it depends on the dealer, I've taken my wheels and tires into my local Honda shop and they installed with no fuss. Of course if I buy my tires through them they charge half labor. If the big...
I'm in IN, right now planning on heading out the friday before, trying to change my vacation to get the weds/thurs before off.
Bumping this back up… anyone have good ideas how to mount a go pro on a Buell? I've got a suction cup mount that I stick on the air box cover, but I'm concerned about it coming off. (hasn't yet) It...