Search:

Type: Posts; User: Rays

Page 1 of 11 1 2 3 4

Search: Search took 0.16 seconds.

  1. Replies
    11
    Views
    464

    I dropped the nut from the front ECM bolt which...

    I dropped the nut from the front ECM bolt which isn't that far behind where you are showing in the photo.
    I looked all over the place and eventually found it sitting on the top of the belt under the...
  2. Replies
    38
    Views
    1,107

    I have sent you a hand drawn simplified circuit...

    I have sent you a hand drawn simplified circuit and a few steps to follow via PM - hopefully that will help.
  3. Replies
    38
    Views
    1,107

    Someone has deleted the front signals by...

    [QUOTE] Someone has deleted the front signals by tying the R brown & L Violet wire (see pics) to the return current in the lighting circuit. It was poorly done. I repaired it (assuming it was done...
  4. Replies
    38
    Views
    1,107

    No - only to the +ve DC side as mentioned above....

    No - only to the +ve DC side as mentioned above.

    "I checked the rectifier/regulator internal readings using diode mode as you have done and I get a very similar reading between each AC input and...
  5. Replies
    38
    Views
    1,107

    I checked the rectifier/regulator internal...

    I checked the rectifier/regulator internal readings using diode mode as you have done and I get a very similar reading between each AC input and the +ve DC output - 0.455v one way and open in the...
  6. Replies
    38
    Views
    1,107

    I can't recall what internal resistance...

    I can't recall what internal resistance measurements of the regulator show (I have done those measurements in the past as I have a faulty regulator here that I started to dissect with a mind to...
  7. Replies
    38
    Views
    1,107

    I am not clear on all of the actual symptoms...

    I am not clear on all of the actual symptoms here?

    Let's take this as three different problems for now (that may end up being incorrect but it sometimes helps to focus the diagnosis.

    1....
  8. Received my rebuild kit on Tuesday ( less than a...

    Received my rebuild kit on Tuesday ( less than a week to here in Australia).
    I can now start work on the restoration of a really toasted 12X pump assembly that I have had in the 'too hard' tray for...
  9. Replies
    2
    Views
    221

    This might be worth a quick look - you didn't...

    This might be worth a quick look - you didn't mention blinkers but this sounds similar to an issue I had with an '06 Uly many moons ago....
  10. Thread: mystery parts

    by Rays
    Replies
    14
    Views
    705

    Don't know about an XB9 but I would think it is...

    Don't know about an XB9 but I would think it is the same as on my Ulys - there is a factory thread insert that is meant to go in the frame and the mounting bolt threads into that.
    See item 12 in the...
  11. Have a look at the last picture in this old...

    Have a look at the last picture in this old thread:
    https://www.buellxb.com/forum/showthread.php?34338-Need-some-help-neutral-light-cluych-weirdness/page2&highlight=neutral+switch
    That was ground...
  12. Replies
    3
    Views
    1,085

    Kit 92030-05Y instructions

    This has diagrams for the early style of H&B luggage.
  13. Thread: Fuel light issue

    by Rays
    Replies
    25
    Views
    8,308

    Where Buell did have a covering on this short...

    Where Buell did have a covering on this short loom they used the expandable type loom covering. This would allow easier fitting over the electrical ends - back in the ancient past when I first did...
  14. Replies
    10
    Views
    1,335

    If you swapped positive and negative in the VR...

    If you swapped positive and negative in the VR then you will have the battery positive going directly to ground via the 30A fuse.

    This recent post related to the same topic gives you a clear...
  15. Replies
    8
    Views
    2,232

    Couple of possible scenarios. Did you pull the...

    Couple of possible scenarios.
    Did you pull the diode and replace during your fault finding? It is in the fuse block, coloured black with a diode symbol similar to this "-|<-".
    If yes, when you...
  16. Replies
    51
    Views
    31,742

    I suppose it is safe to say it shouldn't do any...

    I suppose it is safe to say it shouldn't do any harm to try that and you never know your luck in the big city.
    However, if I had those symptoms I wouldn't ride it any further than I was prepared to...
  17. Replies
    13
    Views
    3,334

    This is a pack I got from an auto-parts shop that...

    This is a pack I got from an auto-parts shop that I carry in my car.

    5662
  18. Replies
    13
    Views
    3,334

    I have seen a bad relay socket overheat so well...

    I have seen a bad relay socket overheat so well worth checking the fit of the female sockets for the relays. Once you get a resistive connection and high current it tends to be a self propagating...
  19. Replies
    9
    Views
    2,749

    Ok, I grabbed a brand new 3-phase regulator from...

    Ok, I grabbed a brand new 3-phase regulator from my spares box and that measures 0 ohms from the ground pin on the '77 connector to the case (I used a digital meter with auto-ranging and measured to...
  20. Replies
    9
    Views
    2,749

    When I was playing with the '77 connector on my...

    When I was playing with the '77 connector on my '06X (ages ago I'll admit), I seem to recall the regulator shut down when it was disconnected and the resulting lack of output with the engine running...
  21. Replies
    25
    Views
    3,101

    But the ignition switch can be the reason you...

    But the ignition switch can be the reason you lose +12v to the blinkers. Some details in this thread:
    ...
  22. Replies
    6
    Views
    1,782

    There is a chance the ignition switch being at...

    There is a chance the ignition switch being at least part of the problem. I had a mysterious intermittent tail light on my '06 Uly that had me puzzled for a while.
    There are two separate contacts in...
  23. Replies
    15
    Views
    3,038

    Well I definitely qualify as one of the 'elderly...

    Well I definitely qualify as one of the 'elderly members' - this picture of my first motorcycle (a 1941 BSA WM20) was taken in 1971.

    3000

    Note the weight saving lack of a front brake and the...
  24. 11volts while running and slowly decreasing...

    11volts while running and slowly decreasing indicates your charging system is not working. There are two main components involved - the stator and voltage regulator. The other possible cause could be...
  25. Replies
    70
    Views
    6,728

    Just submitted the order form and sent Paypal for...

    Just submitted the order form and sent Paypal for one to Australia.
    Thanks for the work to make this happen!
Results 1 to 25 of 273
Page 1 of 11 1 2 3 4