Search:

Type: Posts; User: 1776Brigade

Page 1 of 2 1 2

Search: Search took 0.05 seconds; generated 31 minute(s) ago.

  1. Replies
    7
    Views
    298

    Didn't want to start a new thread, so here is an...

    Didn't want to start a new thread, so here is an update.

    Checked throttle cable, and it appears to be adjusted properly. Granted, I've never adjusted it before.

    Question. After parking in the...
  2. Update: after a stupid merry-go-round of...

    Update:
    after a stupid merry-go-round of choosing race stands to get the bike up, I finally removed tires, and Performance Cycle of Colorado put Michelin Road 5 and new bearings on all around.
    ...
  3. Fellas, can't thank you enough for slow walking...

    Fellas, can't thank you enough for slow walking me through this.

    So, another issue - I assume is common - the bolts holding on the rear fender and front fender have some sort of loctite on them. I...
  4. Just to confirm before I buy the bearings. This...

    Just to confirm before I buy the bearings. This is a two bearing wheel. Correct?
    Thanks in advance. 12229
    12230
  5. Got it. Section 2.6 of manual.

    Got it. Section 2.6 of manual.
  6. Thanks for the info. Lunaticfringe had the same...

    Thanks for the info. Lunaticfringe had the same suggestion to use a dorman unit. I'll look further into that.
  7. Is a 2007 xb12s Actuator compatible with 2009 xbss

    Not ready to pull the trigger on an aftermarket exhaust yet (got some minor maintenance and such to pay for first), but my IEV actuator stopped working. Found a used actuator off a 2007 - looks like...
  8. I have an 2009 xb12Ss. Is there a way to know...

    I have an 2009 xb12Ss. Is there a way to know which rear wheel bearings I need before pulling the wheel? I understand most have a 2 bearing set vs the newer have a 3 bearing set. And is there a...
  9. Thanks for the information. Going to check in...

    Thanks for the information. Going to check in with a local mechanic about replacing wheel bearings.

    And thank you for the clarity between the primary drive chain and the final belt drive.
  10. Belt rub = low tone squeaky sound? Primary Drive belt rubbing

    Sorry for the lame description of the sound. Noticed an odd sound that I first attributed to my front brake rotor as a mechanic I first took it to suggested the rotor is slightly warped, but not in...
  11. Couple thoughts. I went with the xb12Ss because...

    Couple thoughts. I went with the xb12Ss because of the extra wheel base length (54" vs 52" for the xb12S). I'm 6'1" and can flat foot the bike.

    There is a slight difference in seat height between...
  12. Replies
    7
    Views
    298

    I'll walk through the suggestions you made. Yes,...

    I'll walk through the suggestions you made. Yes, the bike was warmed up for over 15 minutes before I made the video.
  13. Replies
    7
    Views
    298

    Throttle Response?

    So, I warmed the bike up, and then took this video to show the throttle response. Not experiencing any problems at all, save the initial throttle response lag. Is this normal?

    And to provide...
  14. Replies
    8
    Views
    304

    Well, that was fun. Pulled apart both rear tail...

    Well, that was fun. Pulled apart both rear tail light assemblies. Broke off a tab on one of the covers. Swapped bulbs...and the same issue - left turn signal in the rear doesn't work, while the front...
  15. Replies
    8
    Views
    304

    Thank you. I'll work through your troubleshooting...

    Thank you. I'll work through your troubleshooting suggestions.
  16. Replies
    8
    Views
    304

    One Taillight not working?

    2009 Buell xb12ss. I did the dual headlight wiring trick so that both headlights are on with high beams. Works great. But, just noticed that the LEFT turn signal is not working properly. The LEFT...
  17. Replies
    8
    Views
    270

    thanks for the information fellas. This is very...

    thanks for the information fellas. This is very helpful and confidence inspiring. I'll probably go the full replacement route if my brother can make a deal on the bike. All the best.
  18. Replies
    8
    Views
    270

    Leaking Clutch line - 07 xb12Ss

    Looking to buy a 2007 xb12Ss with 25k. Has a slight fluid leak from the clutch line where it goes into the transmission. Not being a mechanic, is this an easy fix? Worse case - what might it cost to...
  19. Replies
    8
    Views
    560

    THIS BIKE IS NO LONGER FOR SALE. Did some...

    THIS BIKE IS NO LONGER FOR SALE.

    Did some soul searching - demo rides (Indian FTR 1200S $20,000!!!), and decided to keep this ride for a bit longer.
  20. Replies
    8
    Views
    560

    12sechatch - I understand the hesitation. I...

    12sechatch - I understand the hesitation. I bought this from a Harley dealer in Oregon. had it shipped. Turned out the bike was in great shape. had a local Buell mechanic go thru it, and all he ended...
  21. Replies
    8
    Views
    560

    2009 Buell xb12Ss for sale

    THIS BIKE IS NO LONGER FOR SALE
    I'm selling a 2009 Buell xb12Ss with 12,799 miles on it. It's the Lightning Long version in Cherry Bomb red.

    It's almost completely stock except I did a custom...
  22. Replies
    33
    Views
    1,890

    Is the Interactive Exhaust Valve working on the...

    Is the Interactive Exhaust Valve working on the 2009 xb12ss? (The doo-hickey on top of the air filter that controls the exhaust valve in the muffler)
  23. Replies
    7
    Views
    473

    Thanks for the heads up 34nineteen. I was...

    Thanks for the heads up 34nineteen.

    I was aware a new-to-me muffler won't solve that issue. Kind of stuck in a hard place cause I ain't got the dough to go with a $1,000 exhaust (muffler, new ecm,...
  24. Replies
    7
    Views
    473

    What did you replace this with, and what were...

    What did you replace this with, and what were your reasons? I have a stock exhaust (2009 xb12ss) and I'm in a position to either fix the stock or go aftermarket.
    All the best.
  25. Replies
    11
    Views
    465

    Yes. I ran the diagnostic/setup test from the...

    Yes. I ran the diagnostic/setup test from the manual with the engine off. The Actuator did not move at all.
Results 1 to 25 of 49
Page 1 of 2 1 2