That’s right.
Type: Posts; User: REVOLUTIONary_2B
That’s right.
I have a large, clear WIX fuel filter and I can see nothing in it so far.
Another look
I felt I cleaned this carb well about a month ago. I used Berryman’s carb dip, carb spray, compressed air, and wire (for the tiny port near the jets). I also drained the tank and put in fresh ethanol...
That’s the thing...the next day, I went to start it, it fired right up normally. Ran perfectly up and down several residential streets in all throttle positions. Then, just as I was going to pull up...
Adjusted enricher on the rich side. Still have to spray fuel to start. Once running, idle and very low throttle are fine. Will not accelerate bike in this state. Leans out most of the time, but...
Took enricher apart. Green crud inside. Cleaned. Gets hot when put to 12v. Now how do I adjust it? The threads on the body probably a critical adjustment with as little as this is supposed to move.
I can’t find how to test it anywhere...
Who knows? I’ve been told previously that they never go out, don’t worry about it. Do I need to pull it and observe when I turn the ignition on? Is there a resistance spec? OK to put 12V to it?
I’ve...
Bike sat a couple years after I stopped commuting on it. Ran fine up to about 90mph. Was always a little hard to start cold, especially the longer I didn’t ride it. Fuel started to gel. Cleaned the...
OP here. Received a replacement boot. It fits better and the bike now feels stronger, and withOUT the previous problems mentioned. Bike no longer "coughs" like it used to. Well, much much lighter...
I'm pretty sure at this point the rubber boot doesn't fit tight enough on the carb in the first place, because no matter how tight the band is, the carb can still be pulled off. I actually managed...
Any carb'ed engine may lean-spit a couple times during warmup or even unavoidably while cranking. There isn't any indication that it is running lean at all any other time. Certainly not an issue...
Buellysses, yes that is it in your link. I see no one has chimed in to say that I must not know how to stuff two ends into a clamp and tighten down the one bolt. That's nice. But I'm really...
You're the retarded one in the room this time, Friend :) This post is in the Buell Blast section, and they all have carbs.
Spent the $58 freakin' bucks on the "Wonderpart" everybody on here jerks off thiking about, and, to get right to the point, it won't freakin' stay on! Everytime the bike is a little lean, like...
Still have it? I assume it is black? No interest in my trade?
Is the Buell Pro-Series Intake filter for the Blast supposed to be an oiled filter like a K&N, or is it dry? Anybody know the cleaning instructions?
Clarification: I would say it is actually backfiring (light to moderate. Not super loud), not cutting out while revving to warm it up/keep it running.
Throw me a bone here guys...no ideas?
Is the...
2003 Blast currently 3,960 miles. Owned since last Fall at 2,4XX miles. Buell Pro Series intake, Vance&Hines exhaust. No idea how it is jetted because I bough it this way. Bike is extremely hard...
jakub7: No thanks, its hard enough being speed limited by the setup I have. I just wanted to make sure there wasn't something wrong. I'll ask about my other issues in other posts!
Interested if you still have it.
Interested if you still have it. Ad is expired. Need pics and details.
Expired ad. I'm looking for a 2009 1125R.
Interested...Craig's List ad expired...need pics. Trade for my '06 H-D Nightrod or I'll have to sell it first.