Search:

Type: Posts; User: Barrett

Page 1 of 20 1 2 3 4

Search: Search took 0.20 seconds.

  1. Replies
    8
    Views
    137

    The starter motor is a Mitsubishi Electric...

    The starter motor is a Mitsubishi Electric component. It is bolted onto the left side engine case and engages the ring gear on the outside of the hub assembly, spinning the engine over to start it....
  2. Replies
    8
    Views
    137

    Possibilities: Primary/trans breather hose loose...

    Possibilities:
    Primary/trans breather hose loose at fitting
    Primary/trans fluid level way too high
    Starter motor sealing ring leak
    Rear cylinder rocker box lid breather grommet/breather assembly...
  3. The cable must be adjusted in conjunction with...

    The cable must be adjusted in conjunction with the clutch pack.The pack adjustment screw done first...then the cable.
    A primary/trans fluid (1 US Quart) such as Mobil-1 20W50 motorcycle specific or...
  4. Combination of clutch cable...clutch...

    Combination of clutch cable...clutch pack..primary drive chain all incorrectly adjusted.
  5. Thanks much for the compliment. Just sold both of...

    Thanks much for the compliment. Just sold both of them a few weeks ago to Yamaha collector from up near NYC.
    Price drop on the Buell.
  6. Replies
    5
    Views
    150

    John: It's a very simple straight-forward...

    John: It's a very simple straight-forward procedure. Click link below for X model...click tab for your model year...wheel section...read.

    Axle pinch bolt is on bottom right side of swingarm
    ...
  7. This is great entertainment. Shaughn: That hose...

    This is great entertainment.
    Shaughn: That hose you mentioned actually connects the pump motor outlet to the regulator. Whenever I see a "pressure seems good" comment on here it always takes me...
  8. Sir: Yes on engine rotation for what you intend...

    Sir: Yes on engine rotation for what you intend to do. Fairly simple and straight-forward process. If you need a link to the procedure along with great pics, let me know and will post it up for you....
  9. The bike start and idle well when cold Because...

    The bike start and idle well when cold Because "cold start enrichment" mapping is masking the problem.


    But when hot, the idle start to be ****ed up, drop to stall or idle itself to 2-3K. The...
  10. Thread: piston rings

    by Barrett
    Replies
    67
    Views
    2,176

    Typical causes of excessive engine vibration in...

    Typical causes of excessive engine vibration in the XB-XL-XR rubber mounted engine platform are the following:
    1-One or more mounting points in the engine-to-frame configuration either...
  11. Thread: Blast belt

    by Barrett
    Replies
    25
    Views
    1,511

    Sir: Now trying to obtain OEM P3 belt #...

    Sir: Now trying to obtain OEM P3 belt # GO500.01A7 appears to be very difficult. If I were you, a simple remedy is to obtain 27T front belt pulley for any XL model...plenty for cheap money on...
  12. Replies
    13
    Views
    415

    Sir: My ECM knowledge is minimal and my tuning...

    Sir: My ECM knowledge is minimal and my tuning capabilities are non-existent, but the below link should give you solid guidance and direction. As memory serves but not mentioned here....The...
  13. Replies
    7
    Views
    235

    Been using one of these forever. Few bucks and...

    Been using one of these forever. Few bucks and easy to build. Make the base the approx size of the legs on your floor jack/lift. Use a piece of cardboard to form the pattern of the muffler curvature...
  14. Thread: Stranded

    by Barrett
    Replies
    13
    Views
    517

    IMO I've found using 20w/50 oil in the primary...

    IMO I've found using 20w/50 oil in the primary can make for a grabby clutch, so I've gone back to Formula +, or whatever the clutch mfg you use recommends. I currently have ATF with the ALTA...
  15. Replies
    13
    Views
    415

    Thanks a ton Mike for the very kind words.

    Thanks a ton Mike for the very kind words.
  16. There are no current errors in the "trouble...

    There are no current errors in the "trouble codes" section of ECM droid, but the "stored errors" sections seems to indicate AMC stuck open, AMC stuck closed, and AMC short to ground.

    Interactive...
  17. Thread: Stranded

    by Barrett
    Replies
    13
    Views
    517

    Quick fix info for shop guy so that you can make...

    Quick fix info for shop guy so that you can make it home:
    1-Obviously remove primary cover and replace broken bolt you speak of. Should be common shop hardware.
    2-Remove entire clutch pack...
  18. Thread: XB/Tank

    by Barrett
    Replies
    4
    Views
    231

    Correct Josh. All years S...SX...R...SL...SCG...

    Correct Josh.

    All years S...SX...R...SL...SCG the same.
    All years X..XT....Ss....Stt...XP the same but different that ones above.
  19. Replies
    13
    Views
    415

    YES. Part of the pump assembly. All XB models all...

    YES. Part of the pump assembly. All XB models all years use same sensor. Part # NLA and delisted several years ago.
    I have them here. 10% off for board members. Free shipping.
    ...
  20. Thread: Really??

    by Barrett
    Replies
    5
    Views
    285

    Hey John: How have you been? John Lutz here. Is...

    Hey John: How have you been? John Lutz here. Is that AMG # you listed the 1125 model 145T belt? I can run the # Monday morning and see what's out there? And isn't Surdyke in western PA? If so, you...
  21. Brian: I have almost zero knowledge when it comes...

    Brian: I have almost zero knowledge when it comes to the nuances of ECM mapping and haughty vernacular associated with same. But I do know this:
    1-Try sending Adams a PM on here. He's still fairly...
  22. Replies
    11
    Views
    608

    Inventory update: #1---2 left in stock #2---...

    Inventory update:

    #1---2 left in stock
    #2--- sold out
    #3---1 left in stock
    #5---1 left in stock
    #6---1 left in stock
    A few new and dealer take-off turn signals left in stock
  23. Entirely electrical-related. And there is NO...

    Entirely electrical-related. And there is NO speedo or tach cables on any XB models. Both gauges driven electronically via the onboard ECM. The ECM receives coil pulse signals which trigger the...
  24. Hey Mike: How are you? John Lutz here. I have a...

    Hey Mike: How are you? John Lutz here. I have a dealer account via Harley Davidson with Motion-Pro. Joe Fratis runs entire Motion-Pro production and coordinates production with requested dealer...
  25. So the pump is priming nicely, but there must be...

    So the pump is priming nicely, but there must be a leak within the fuelpump assembly or something wrong with the new one.
    unfourtunately i bought the pump online and not from them. But they will...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4