Search:

Type: Posts; User: samuelseggs

Page 1 of 3 1 2 3

Search: Search took 0.08 seconds.

  1. Replies
    8
    Views
    657

    Oh well, i had to do most things myself, it's...

    Oh well, i had to do most things myself, it's always not easy. I don't want the same mistake happen twice. I still have my xb9sx i use as parts swap.
  2. Replies
    8
    Views
    657

    Thank you njloco, I just read about this in the...

    Thank you njloco, I just read about this in the manual, Phew i'm looking for the tool to do this.
  3. Replies
    8
    Views
    657

    Thank you for your previous response. I must...

    Thank you for your previous response. I must apologize for the mistake I made in my previous message. I actually use 20w50 Motul Oil for my 09 xb9sx. Unfortunately, my motorcycle sustained damage...
  4. Replies
    8
    Views
    657

    Thank you Cooter, We only have less than 5...

    Thank you Cooter,

    We only have less than 5 Buell in my state/country and I own 2. We don't have any mechanics who understands the bike. The other bike got totalled because I trusted a mechanic wth...
  5. Replies
    8
    Views
    657

    New Oil Does not trigger Error 13

    I've been experiencing a persistent issue with my bike, and it's been quite a journey trying to diagnose and fix it. The main problem arises when I ride for around 30 minutes – the bike starts...
  6. I have this same problem. It started happening...

    I have this same problem. It started happening after I wrapped up my exhaust. When I read for codes. I can see any.
  7. Replies
    6
    Views
    1,851

    Is the exhaust available?

    Is the exhaust available?
  8. Apologies for delayed response. While checking...

    Apologies for delayed response. While checking through other threads on Badweb most people confirmed that i need to change the CPS. I got one off eBay, it took a while to reach me... Missing item......
  9. 06 Ulysess xb12x Sputtering and Shooting when Hot

    This is going to be my second buell. I lost hope taking the buell into the Auto Store for fix as they make very poor decision and i mostly have to go back with problem worse or some new problem.

    I...
  10. Replies
    7
    Views
    1,318

    Today I got a Buelltooth device.. Hooked it up...

    Today I got a Buelltooth device.. Hooked it up and got error 11 TPS too low/short to Ground.

    I also checked AFV and it was reading 115% so I reset back to 100%. I tried doing a live test. By...
  11. Replies
    7
    Views
    1,318

    Here is a video of the bike...

    Here is a video of the bike
    https://youtu.be/NSr7SbtIjV0
  12. Replies
    7
    Views
    1,318

    Any idea how this is done for this bike.

    Any idea how this is done for this bike.
  13. Replies
    7
    Views
    1,318

    2006 Buell ulysses Red Lights

    I just got an 06' ulysses buell, less than 40k mileage.

    Initially I noticed that the RPM gauge works only when you twist the handle to the left. I cleaned out the ground wires under the headlamp....
  14. Replies
    6
    Views
    945

    I have cleaned out the grounds at the steering...

    I have cleaned out the grounds at the steering neck but still not working perfectly. I will have to read through the manuals
  15. Replies
    1
    Views
    789

    Using a 14ah battery in my Ulysses

    I have a 2006 Ulysses. I can't seem to get a 12v/12ah battery. Can I use a 12v/14ah battery as replacement.
  16. Replies
    6
    Views
    945

    Thank you very much. I noticed if I turn the...

    Thank you very much. I noticed if I turn the handle to the left... The gauge works again. Could it be a loose wire at the handle bar?
  17. Replies
    6
    Views
    945

    RPM does not work

    Hello,

    Good day. I have an 06 Xb12 Ulysses.
    Today I noticed that the RPM does not read. When I switch key position to on. I get the early sweep. Both RPM and Speedo sweeps to the right. However...
  18. Replies
    63
    Views
    51,643

    I was able to take a reading of the stator and it...

    I was able to take a reading of the stator and it shows 65v-120v when i rev and 35v when idle, is this normal? SHould i change stator also. i don't want to buy another VR and it goes bad again.
  19. Replies
    63
    Views
    51,643

    I'm in Nigeria, yes postal service sucks and...

    I'm in Nigeria, yes postal service sucks and first class air packages gets lost.

    John can I also test the stator to be sure it's in good state..

    I thank you.
  20. Replies
    63
    Views
    51,643

    Thank you very much.. That video was helpful.. ...

    Thank you very much.. That video was helpful..
    Here is a video

    https://youtu.be/cleYUQrxQls
  21. Replies
    63
    Views
    51,643

    Okay I went to the store and got this.. Please...

    Okay I went to the store and got this.. Please how do I use.. 12734
  22. Replies
    5
    Views
    6,728

    I have been able to put the new gaskets on my...

    I have been able to put the new gaskets on my bike. But i now face a whole new set of issues

    Here is what i did.
    1. I changed the front block gasket only, since the rear block had no leaks
    2. I...
  23. Replies
    63
    Views
    51,643

    12731 here is the reading from my buelltooth

    12731 here is the reading from my buelltooth
  24. Replies
    63
    Views
    51,643

    My bike was cutting fuse. I found out the Voltage...

    My bike was cutting fuse. I found out the Voltage Regulator was bad. I had an old one from my ducati(scrapped) luckily it was same match.

    After a 2 day ride.. My CEL came on. I checked with the...
  25. Replies
    5
    Views
    6,728

    Thanks John, I'll look into these and give you...

    Thanks John, I'll look into these and give you feedback, are there any other thing to look into since I'm going to rotate the engine.?
Results 1 to 25 of 65
Page 1 of 3 1 2 3