Search:

Type: Posts; User: samuelseggs

Page 1 of 3 1 2 3

Search: Search took 0.15 seconds.

  1. Apologies for delayed response. While checking...

    Apologies for delayed response. While checking through other threads on Badweb most people confirmed that i need to change the CPS. I got one off eBay, it took a while to reach me... Missing item......
  2. 06 Ulysess xb12x Sputtering and Shooting when Hot

    This is going to be my second buell. I lost hope taking the buell into the Auto Store for fix as they make very poor decision and i mostly have to go back with problem worse or some new problem.

    I...
  3. Replies
    7
    Views
    538

    Today I got a Buelltooth device.. Hooked it up...

    Today I got a Buelltooth device.. Hooked it up and got error 11 TPS too low/short to Ground.

    I also checked AFV and it was reading 115% so I reset back to 100%. I tried doing a live test. By...
  4. Replies
    7
    Views
    538

    Here is a video of the bike...

    Here is a video of the bike
    https://youtu.be/NSr7SbtIjV0
  5. Replies
    7
    Views
    538

    Any idea how this is done for this bike.

    Any idea how this is done for this bike.
  6. Replies
    7
    Views
    538

    2006 Buell ulysses Red Lights

    I just got an 06' ulysses buell, less than 40k mileage.

    Initially I noticed that the RPM gauge works only when you twist the handle to the left. I cleaned out the ground wires under the headlamp....
  7. Replies
    6
    Views
    545

    I have cleaned out the grounds at the steering...

    I have cleaned out the grounds at the steering neck but still not working perfectly. I will have to read through the manuals
  8. Replies
    1
    Views
    401

    Using a 14ah battery in my Ulysses

    I have a 2006 Ulysses. I can't seem to get a 12v/12ah battery. Can I use a 12v/14ah battery as replacement.
  9. Replies
    6
    Views
    545

    Thank you very much. I noticed if I turn the...

    Thank you very much. I noticed if I turn the handle to the left... The gauge works again. Could it be a loose wire at the handle bar?
  10. Replies
    6
    Views
    545

    RPM does not work

    Hello,

    Good day. I have an 06 Xb12 Ulysses.
    Today I noticed that the RPM does not read. When I switch key position to on. I get the early sweep. Both RPM and Speedo sweeps to the right. However...
  11. Replies
    62
    Views
    46,612

    I was able to take a reading of the stator and it...

    I was able to take a reading of the stator and it shows 65v-120v when i rev and 35v when idle, is this normal? SHould i change stator also. i don't want to buy another VR and it goes bad again.
  12. Replies
    62
    Views
    46,612

    I'm in Nigeria, yes postal service sucks and...

    I'm in Nigeria, yes postal service sucks and first class air packages gets lost.

    John can I also test the stator to be sure it's in good state..

    I thank you.
  13. Replies
    62
    Views
    46,612

    Thank you very much.. That video was helpful.. ...

    Thank you very much.. That video was helpful..
    Here is a video

    https://youtu.be/cleYUQrxQls
  14. Replies
    62
    Views
    46,612

    Okay I went to the store and got this.. Please...

    Okay I went to the store and got this.. Please how do I use.. 12734
  15. Replies
    5
    Views
    4,870

    I have been able to put the new gaskets on my...

    I have been able to put the new gaskets on my bike. But i now face a whole new set of issues

    Here is what i did.
    1. I changed the front block gasket only, since the rear block had no leaks
    2. I...
  16. Replies
    62
    Views
    46,612

    12731 here is the reading from my buelltooth

    12731 here is the reading from my buelltooth
  17. Replies
    62
    Views
    46,612

    My bike was cutting fuse. I found out the Voltage...

    My bike was cutting fuse. I found out the Voltage Regulator was bad. I had an old one from my ducati(scrapped) luckily it was same match.

    After a 2 day ride.. My CEL came on. I checked with the...
  18. Replies
    5
    Views
    4,870

    Thanks John, I'll look into these and give you...

    Thanks John, I'll look into these and give you feedback, are there any other thing to look into since I'm going to rotate the engine.?
  19. Replies
    5
    Views
    4,870

    Complete Gasket for Buell xb9sx 2009

    My bike has done about 29k miles. I noticed oil leakage around the cylinder head and around the rocker box. So I guess it's time to change the gasket. I have looked up eBay and Amazon. But could not...
  20. Replies
    104
    Views
    128,529

    Cross-reference parts for xb9sx 2009 front fork?

    Cross-reference parts for xb9sx 2009 front fork?
  21. So, this morning on my way to work, I got...

    So, this morning on my way to work, I got warning light, I hooked up to ecmdroid and I got error "clutch short to ground/broken" yeah, which is understandable 'cos I bridged the connectors. But then...
  22. Clutch Switch or Crank Position Sensor.

    On my way back from work it started to rain.. I was 10min away from home so I continued riding in the rain. The next morning I started the bike.. Everything seem fine, but as soon as I'm in the first...
  23. Replies
    54
    Views
    38,732

    Thanks Cooter, what other thing do I need to...

    Thanks Cooter, what other thing do I need to check??
  24. Replies
    54
    Views
    38,732

    After thorough cleaning of grounds, i still have...

    After thorough cleaning of grounds, i still have misfire. any other thing to be on the lookout for?

    1. I have a wire from the braided earth strap to negative on battery
    2. Cleaned the grounds...
  25. Replies
    40
    Views
    10,269

    Thank you, Okay, I have a spare 02 sensor...

    Thank you,

    Okay, I have a spare 02 sensor I'll fix and test again, is there a way I can test for injector not fully closing or faulty pressure regulator. My bike is a 2009 xb9sx DDFI3 BUEZD...
Results 1 to 25 of 58
Page 1 of 3 1 2 3