I live in California where I'm pretty sure all gas is blended with Ethanol. Never had a problem in any of my bikes.
27,000 miles on my last Buell. Not a single engine problem using 91 octane ETHANOL blend.
I live in California where I'm pretty sure all gas is blended with Ethanol. Never had a problem in any of my bikes.
I use JP-8 (NATO F-34)..
Diesel ;):D
Where I live in Iowa there are only two stations that have straight 91 no ethonol gas. Last time I took a long ride I stopped about six times and everywhere had blended fuel.
one of these days ill pick up a can of race fuel... see what that does..
WOW lot's of info here (whether correct or incorrect) lol.
There are two different things to consider: octane rating and ethanol content.
Octane rating: Use what is listed in the manual at a minimum. Higher octane than needed is a waste and does not increase power or any thing like that, but it is safe. Do not use octane that is lower than required or you will get detonation. Also, running much higher octane than required can cause carbon deposit build up. Octane rating is defined literally as the resistance to detonation, a higher octane rated fuel burns slower and has more resistance to detonation than a lower rated octane fuel. Typically, higher octane is required with more compression and more timing advance. Run what's required by the manual. The xb's I believe require 91 octane. Here in FL usually you have 87, 89, and 93, so run 93 in this case. If you have the choice between 91 and 93, choose 91. If you really want to get it to 91, then fill half tank of 89 and half tank of 93 and "wala" you have 91.
Ethanol content: Again, like the manual says, the 10% ethanol mix will not harm the engine. Now, if I had the choice to buy pure gas I would, because it is better. It will get slightly more mpg and power (ethanol contains less energy than pure gas per the same volume). Ethanol also will deteriorate rubber hoses, gaskets, o-rings, etc. in time. Using a 10% mix isn't a huge deal, but I would never run E85 (85% ethanol) in my vehicles(and my truck is actually a flexfuel vehicle).
Here in Florida I think that practically all gas is 10% ethanol blend. I don't remember the last time I saw a pump here that wasn't(except right next to the drag strip...).
If the pump says "91" then it is 91 octane, whether it has 10% ethanol or not.
ethanol drys out rubber e-85 will eat alum fuel lines unless they have a special coating so dont use any fuel that has ethanol in it
It's all safe, California has more cars than any state in the union and more lawyers too. If the blends would destroy their Mercedes Benz's, Ferrari's and Bentley's the oil companies would be paying billions in law suits here. Don't worry about Ethanol.ethanol drys out rubber e-85 will eat alum fuel lines unless they have a special coating so dont use any fuel that has ethanol in it
Snrusnak you are exzactly right. The manual on my 2006 buell blast says to run 87 octane or higher. I have run higher octane in my bikes in the past but on any air cooled motors I have found it to be better to run only what it needs. Although I have never had a high performance one. I did have a sportster with 55000 miles on it that spent its whole life with 87. It got hit by a car with me on it, it never blew up from it. Like you said if you put in a different timing module or change the compresion you will have to run higher. Possibly even intake and exaust changes could make the difference. I do know from dirt bikes if the bike does not like the octane you will know in about 10 seconds from the sound of the motor.