Boss, Joel, Nitto and Hammel. Your decals went out today. For those that ordered or paid today, sorry yours didn't go out. I keep the decals at my house. I don't bring them to work with me. They will go out tomorrow.
Boss, Joel, Nitto and Hammel. Your decals went out today. For those that ordered or paid today, sorry yours didn't go out. I keep the decals at my house. I don't bring them to work with me. They will go out tomorrow.
Running out of lightnings! One large white and 2 small silvers left!
Come on firebolt riders, why are you guys not buying?
Maybe if the knee was touching..... ;)
thanks dave
Hey Dave I'm in afghanistan and only have internet on my blackberry so I can't paypal. Can I paypal money for stickers in mid october when I'm home on r and r?
What would you like Army MP? I can set some aside for you. Also, here is the paypal app for blackberry. link
Thanks Dave, signal is so bad here it takes forever to load anything. What do you have left?
Got decals yesterday they look great thanks dave
Here are instructions from Matter for instalation
"The decal installation is easy, just be patient, and you will achieve perfect wrinkle free, bubble-less graphics. Make sure the surface is clean. Start by holding the decals in place to get the feel of where they go. Grab a heat gun or blow dryer, a plastic squeegee and a spray bottle with water and a few drops or more of liquid dishwash soap in the water. Carefully peel the backing off the decal to expose the adhesive side, leave the paper covering on the front side for now. Medium MIST with the soap/water mix the area where the decal goes. Then carefully place the decal where it goes while trying to make the center contact first as not to trap air bubbles. When it is just set in place, don’t press, just check the fit as the water mixture will allow you to slide it a little or even lift it and set again if needed. When satisfied with the placement, you can begin to squeegee the water out starting from the center working towards the ends. Try to squeegee the decal out a little, don’t rush it, just do what you can as the stiffness of the outer paper will not let it stretch where it needs to. Go grab a cold one and leave it alone to dry a bit. Depending on temp and how much water you used, try in 10-20 minutes or so to SLOWLY peel the outer paper off the decal, just don’t allow it to slap back down as a wrinkle or bubble may be trapped. If the vinyl won’t stay stuck to the frame, wait a little longer and try again. Don’t freak if you have a few tiny bubbles you are unable to squeegee out as they will often dissipate in a day or two. Most important thing is don’t rush it.
Post your results on the Buell XB thread for others to see your example!"
Come on firebolt guys, make some orders. I have a lot left!