Boob! I was thinking wtf how come this guy can lift his with his fender on?
might need to call them for a different pin...... the 18s not really working. i had mine on the top setting as i didnt want the bike really high off the ground.
yeah definately seems like the fenders going to have to come off....sucks i just use these for storage lol.
Boob! I was thinking wtf how come this guy can lift his with his fender on?
Lol! My bad! Now its a damn challenge! :DBoob! I was thinking wtf how come this guy can lift his with his fender on?
I feel if the peg is trimmed slightly it might work with the fender on or if the angle was slightly different
anyone mod a T-rex so you don't need to remove the front fender? Pics if you did!
Just bought a set from MJ Moto and same issue,,, the angle of the pin is about 45 degrees,,, when it should be about 20 degrees. Just sent them a message and waiting to see what there answer is,,, I don't want to take the front fender off either. That is just a dumb requirement IMO.
Wish I would have found this post a few days ago. I will post the answer / solution as soon as I can figure it out. May just bend the pin for the correct angle.
My set of $90 ebay stands fit perfectly. Still holding strong 5 years later.
Well, never heard from MCMoto so I modified it and it works great now. Had to elongate the pin hole so the pin would angle up to the same angle as the head.
I did not have to grind the pin,,, 18 works fine.
IMG_1023.jpgIMG_1024.jpgIMG_1025.jpgIMG_1026.jpgIMG_1020.jpg
Last edited by antioch01; 02-22-2019 at 03:13 PM. Reason: 18 mm pin
The front triple stand fitment on mine looks exactly like your last picture. If I paid $150 for a front triple stand though, personally, I would not be doing any modifications on it. That thing better fit like a glove or back to the store it goes.......but that's just me.