Anybody know if there are any other codes listed in the 2009 or 2010 xb electrical manual?
Im getting error code 62, but I dont see it listed anywhere.
Bike runs fine other than the warning light.
2009 XB12SS
DDFI Trouble Codes
Code No. Fault Condition
11 Throttle position sensor
13 Oxygen sensor
14 Engine temperature sensor
15 Intake air temperature sensor
16 Battery voltage
21 inter active muffler control
23 Front fuel injector
24 Front ignition coil
25 Rear ignition coil
26,27 clutch and neutral switch
32 Rear fuel injector
33 Fuel pump
34 iac
35 Tachometer
36 fan voltage
37,43 speed sensor
44 Bank angle sensor
45 side stand sensor
46 start relay
47 aux power outlets
52, 53, 54, 55 ECM failure
56 crankshaft position sensor
Anybody know if there are any other codes listed in the 2009 or 2010 xb electrical manual?
Im getting error code 62, but I dont see it listed anywhere.
Bike runs fine other than the warning light.
2009 XB12SS
Couldn't find cel code 62 anywhere, you're sure that's the code it's showing? I'm out of town right now, will check my manuals when I get home Monday.
Thanks for the reply Miami78
Yes, I re-checked several times. 6 quick flashes, followed by 2 slow, repeating continuously.
11 Throttle position sensor ?Yes, I re-checked several times. 6 quick flashes, followed by 2 slow, repeating continuously.
Thanks oh9bolt,
Based on the link you posted I learned that the 6 quick fllashes are not part of the code.
There was also a very long slow "flash" that I didnt mention earlier.
So my trouble code is 21, a problem with the exhaust valve.
For anyone else trying to decipher the check engine light, I found the full electrical diagnostic manual for 08':
http://munck06.free.fr/BUELL/manuals...s%20Manual.pdf