Page 3 of 4 FirstFirst 1234 LastLast
Results 21 to 30 of 39

Thread: 2005 XB1200Scg No Start. Help

  1. #21
    Senior Member
    Join Date
    Mar 2010
    Posts
    7,805
    2 year old gas? did you swap relays or replace

  2. #22
    No new gas. Bought 2 new relays. It turns over now, bit no starting. I had it running fine before I screwed up w. The battery

  3. #23
    Senior Member
    Join Date
    Mar 2010
    Posts
    226
    i dont blame you for refusing to believe its what i said it would be. i was the same way. i hope im wrong too. idk any other way to help other then check out some ole threads for the same issue, i promise you will run into at least a couple to choose from. good luck devil.

  4. #24
    Kelly, no problem man. Just pissed. Havemt ridden in two years. About to pull some codes and see what it says...keep ya posted

  5. #25
    Ok I pulled codes for both injectors. Nothing else. Does the ecm have its own code, or can a bad ecm throw those codes?

  6. #26
    Senior Member
    Join Date
    Mar 2010
    Posts
    226
    good morning. bad code for ecm in my case was many different codes at once. there is also one or two codes that are fro ecm as well sorry dont remember them off the top of my head. good luck

  7. #27
    Senior Member
    Join Date
    Mar 2010
    Posts
    7,805
    DDFI Trouble Codes

    Code No. Fault Condition
    11 Throttle position sensor
    13 Oxygen sensor
    14 Engine temperature sensor
    15 Intake air temperature sensor
    16 Battery voltage
    21 inter active muffler control
    23 Front fuel injector
    24 Front ignition coil
    25 Rear ignition coil
    26,27 clutch and neutral switch
    32 Rear fuel injector
    33 Fuel pump
    34 iac
    35 Tachometer
    36 fan voltage
    37,43 speed sensor
    44 Bank angle sensor
    45 side stand sensor
    46 start relay
    47 aux power outlets
    52, 53, 54, 55 ECM failure
    56 Cam sync failure


    you need to check for power to the coil and injectors 12 volts and check for 5 volt refrence to the tps,iat. also check for a pulse at the injectors and then post your results

  8. #28
    Ok will check that after work. But I pulled code 23 and 32. Thats it

  9. #29
    Just ohmd the injectors. They tested fine. I got 12 v going to the injector harnesses. 12v going to the coil as well. Still no start. The bikes in neutral, but the neutral light isnt on. Gotta pull the clutch in to turn it over. But still nothing. It seems like the relays are getting warm too. Wtf. Anyone.....ideas please?

  10. #30
    Neutral safety switch is smoked. I can bypass it and the bike finally shows its in neutral. Still no start. Still throwing injector codes



Page 3 of 4 FirstFirst 1234 LastLast

Similar Threads

  1. 2005 Buell xb9sx high afv hard to start
    By DualSportDad in forum Troubleshooting
    Replies: 2
    Last Post: 12-29-2014, 02:55 AM
  2. 2005 Buell xb9sx won't start giving me codes 44-36
    By Kellluca in forum Buell Lightning XB12S, XB12Ss, CityX, XB12Scg
    Replies: 3
    Last Post: 05-27-2014, 01:51 AM
  3. 2005 XB12S Won't Start... no help from ECMSPY
    By DamnRock in forum Troubleshooting
    Replies: 7
    Last Post: 04-06-2014, 04:40 AM
  4. Replies: 2
    Last Post: 05-06-2012, 08:59 AM
  5. 2007 XB1200Scg-First-time Bueller!
    By KYmxracer52 in forum Buell Lightning XB12S, XB12Ss, CityX, XB12Scg
    Replies: 20
    Last Post: 12-22-2011, 09:51 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •