a length of threaded steel, 4 lock washers, 2 bolts and a set of wheels for each axle.
what do i need to make my on skateboard wheel Axle sliders?
a length of threaded steel, 4 lock washers, 2 bolts and a set of wheels for each axle.
a good crash to get you pissed off at your skateboard so much that you wont ever want to ride it again.
2 bolts? and why do you need 4 washers per axle?a length of threaded steel, 4 lock washers, 2 bolts and a set of wheels for each axle.
i would just think you would use one piece of allthread rod, 2 lock nuts, and 2 skateboard wheels for each axle.. where do you use the bolts?
the bolts go on the ends of the all-thread to hold the skate board wheels against the forks/ swing arm.
a bolt does not attach to all thread rod. i think you mean a nut.
Yes I did mean nut, my bad, thanks for the catch Kona!
so it just neet 1 piece of allthread rod, 2 lock nuts, and 2 skateboard
and thats it? sweet thx
what length should i take for the front/rear allthread rod
DIY - Axle Sliders - 4' length of 1/2" allthread (hacksaw to desired length) - Mating washers & nuts - 2 Skateboard wheels