Trailering sir, enjoy
Trailering sir, enjoy
Yes, Gatlinburg bound.
- Installed Buelltooth and ECMSpy
- Found Active Exhaust stuck closed
- Wired open Active Exhaust
- TPS Reset
- Verified that runs like crap if you don't back out Idle Adjustment
- Got only Clicks when trying to start
- Cleaned and Dielectric Greased Grounds and + Supplies
- Charged battery
- Performed another TPS Reset with Idle backed out - Adjusted Idle - Verified that this method works way better.
Adjusted suspension to Factory Recommended Short Lard Ass settings
Removed Caution Sticker - Performed another TPS Reset
Throttle Response on Low End MUCH cleaned up. Hitch in the 2000-3000 RPM range is gone. Feels much better in low speed situations. Butt dyno shows 22% Torque Increase across power band.
And I found a small crack on my Cherry Bomb Airbox Cover - Any recommends on how to forestall further damage/breakage?
Cherry Airbox Crack.jpgCherry Ann just off the Trailer.jpg20210902_191359.jpg
but a little super glue on the area, just like how they do it on a windshield should prevent it from getting worse
and then
Make sure you have the plastic washers for the bolts and don't over tighten them.
Jack-O-Lantern
2006 Buell XBRS LightningBolt
http://www.buellxb.com/forum/album.php?albumid=129
The translucent plastic have their own hardware type to help with over tightening and cracking them.
B19B4DD5-88B4-48A1-9C2D-8F5CB26CDB6B.jpgI am by no means an upholsterer , but I ordered a Tappezzeria Italia seat cover, and gave it a shot .9F62471B-A475-4B48-93DA-A7831D8FBFDF.jpg Yes my shed is a hot mess!9F62471B-A475-4B48-93DA-A7831D8FBFDF.jpg
I am by no means an upholsterer , but I ordered a Tappezzeria Italia seat cover, and gave it a shot .9F62471B-A475-4B48-93DA-A7831D8FBFDF.jpg Yes my shed is a hot mess!9F62471B-A475-4B48-93DA-A7831D8FBFDF.jpg
A little freshing up on my own modified muffler muffler.jpg