What did you do for your Buell today?

[wr5757]

Finished the first phase of my Iron Man (Arc Reactor) timing cover mod. Next step is to add LED's. I also have a thread Buell Arc Reactor Build but wanted to share with everyone here in case you haven't seen it yet.

[williegoat]

I just got done installing the Hawk on my S3, and it sounds GREAT!
I now have a Hawk Muffler on my Tuber and my XB and I wouldn't have it any other way. I think they both sound just the way these bikes should; strong but civilized.

[neilrl79]

Yesterday I picked up my chinese levers from the post office and installed them. Took less than 5 minutes and no modification was necessary. They will do just fine till I can afford better replacements. I then went for a nice ride out to Lancaster PA.

[GAXB9R]

Installed 55W 6000 HID kit. Not to bad on difficulty on the install. Really just plug and play sort of;) Will definetly be much better than the stock ones that were barely brighter than my iPhone screen:D

[NwRider]

Still doin bodywork to my seat cowl.. decided to cut off some unused tabs to clean her up.

Have a crazy idea for a timing cover but did this for the time being since the paint was flaking off the original.

[BuellyBagger]

was going to wash it... rode it instead. seemed like that was more worth while:D

[07Bolt_SOvitt]

Installed my new 50dro pulley cover. :D

[Bolty]

Today my T-Rex stands and new key came.

[Sirius815]

Put in an order for the new Bridgestone S20 tire for the front along with a set of HH pads.

[MotoPhreke]

Heavy Sigh, "I'm gonna take it apart, again"