-
09-30-2012, 05:08 PM
#711
Member
Yesterday I changed the primary oil and flushed the brakes with fresh fluid. Polished my plastics with the Novus kit that I just ordered. Looks and runs great!
-
10-04-2012, 01:46 AM
#712
Senior Member
Painted this thing, after bending it so my clutch cable boot stops melting.
-
10-06-2012, 03:58 PM
#713
-
10-06-2012, 04:36 PM
#714
I beat the crap out of both of mine today, ran them on a dyno to see what they'd make.
Don't know for sure where the xb started at, but it's at 84 hp and 63 ft/lbs of torque, the 1125 is 139 & 89 ft/lbs.
-
10-07-2012, 12:42 AM
#715
Senior Member
I installed ANOTHER Speedo sensor and was shocked that HD had sold the rear pads they had in stock last week. Who in my area has a tuber?! Thinking about salvaging a the pads from a spare caliper I have but they got soaked in brake fluid and may just fall apart.
-
10-07-2012, 08:41 PM
#716
Senior Member
And the trike conversion is almost complete!
And yes... Im totally kidding. Rotor bolts are soooo stuck I was gonna mount my extra wheel... But no shops open today to swap my tire!
If I can't ride maybe I should just mount it up with the ****e tire for a smoke show... Sigh.
-
10-08-2012, 12:56 AM
#717
Senior Member
-
10-08-2012, 02:10 AM
#718
Senior Member
Installed my Hawk. Bad ass!
-
10-08-2012, 06:32 PM
#719
Senior Member
I installed a Free Sprits belt tensioner on the LightingBolt (Frankenstine Track bike), going to try it out Sunday on the Patroit course at VIR.
-
10-11-2012, 05:38 AM
#720
Member
Ordered a James top end gasket set for my 99 cyclone, typical evo base gasket problems.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules