Reply With QuoteIve tried the Duralast TPS213 and it didn't work for me.
The position inside the sensor is turned a bit, which wouldn't allow the TPS register a reading.
Any ideas?
07 Buell XB12Ss
Buell Relays - (Autozone) Duralast Pt # 19283
Ive tried the Duralast TPS213 and it didn't work for me.
The position inside the sensor is turned a bit, which wouldn't allow the TPS register a reading.
Any ideas?
07 Buell XB12Ss
Not sure about the part number but I know there are sensors that have the wires coming out the top and others out the bottom, but if you can put the sensor on then twist it so that the mounting holes line up it should be fine once you reset the tps back to zero.
Edit: pictures help
Anything for a fuel pressure regulator?
Or where I can buy one and the hose that's in the fuel pump assembly??
the pressure regulator was specifically made so probably from someone that's parting a bike or a dealership will make you buy a whole assembly I believe. Depending on what year your bike was the hose should be available at any ace hardware. They changed the clamps and the hoses depending on year.
Wolf by any chance do you know what that hose is called and/or what size do I need?
Thanx, DiRT
I think it's a 1/4 inner diameter fuel line, I can check tomorrow. I already have a pump assembly taken apart that I could check with.
Really only 1/4inch? I thought it was a lil bigger. I'm not sure tho cause my pump assembly doesn't have it. My FPR sits on top of my pump. My pump being the mustang pump and a friend an I have determined I'm not getting a good seal. So need to figure something else out. And I think the hose will do it. Cause if I lift the reg any higher it wire won't rich the guide rodes to keep it in place so I'm thinking I could move it to the side. Here's a pic of stock pump
Mustang pump
FPR
It may be the actual 3/8 fuel line, I'm not sure since I won't be home til tonight though.
Ya ID looks like 3/8. Do you know what that fuel tube is called?
Posting Permissions
