How did you mount the left side ZTL 2
I'm running an aftermarket 21mm radial pull master cylinder with dual stock lines; one to each caliper.
How did you mount the left side ZTL 2
Hello , OILDRP1 , turboraven has not post for a few yrs , very nice set up with the dual ZTL2 x 2, major stopping power more then needed. IMHO
past thread http://www.buellxb.com/forum/showthr...ors-Projectors
Last edited by Silverrider; 08-23-2017 at 12:01 AM.
There's no more stopping power with that bike than any other Buell with the ZTL2 system.
There's no caliper on the left side.
Last edited by SEXT9; 08-23-2017 at 01:35 AM.
I'm pretty sure the second caliper never made it on to that bike. I find it funny that he speaks of the radial and dual lines that he ran on the bike.
I remember following his build. And I read his build thread all the way to the end. It never did seem to get done. For a long time I thought it wasn't possible until I saw someone create a left fork bottom.
http://www.badweatherbikers.com/buel...tml?1357935805