No, put the spring on it.
This may sound crazy but my blast has droped the idle air screw twice. Should I put some locktight on it?
at first the o ring was missing. So I bought a repack kit. Took it for a quick ride around the block and it would not idle when I get it back home. So I took a quick look and the screw had droped out. Replaced the screw and another repack kit, and it happened again
Did you put the spring on it and adjust it properly? When installed properly, there is a lot of tension on that screw, it does not simply fall out.
I tightened it lightly and then backed it out 2.5 turns
Do you have the spring on it?????
This still remains unanswered.Do you have the spring on it?????
You need to tighten it all the way down, it will get very tensioned before you actually bottom it out.
I have the spring washer and o-ring on it
I put some teflon tape on the screw and it hasent moved at all.
good!