Results 1 to 4 of 4

Thread: Blast died after Bump

  1. #1
    Hit a set of tracks at high speed and bike died. I was thinking it was the spark plug, but that was dry when I took it out. Plug is due for a swap as I'm sure it's original hardware. It does seem as if it it's not getting gas for some reason???

  2. #2
    Check your carb intake boot. I bet it is off, and you are right, it is not getting gas/air mixture

  3. #3
    Boots fine. Turns out it was the plug. Swapped out for iridium. I'm assuming the engine heat had evaporated the moisture from stock plug by the time I got her out.

    On a good note. I did have the time to install my new intergrated tail light.
    Sooooo nice!!!

  4. #4
    Good deal!!



Similar Threads

  1. 03 blast died when hot
    By buellproblems in forum Troubleshooting
    Replies: 6
    Last Post: 04-27-2015, 12:05 PM
  2. Bump start an 1125?
    By Bossanova in forum Buell 1125R
    Replies: 19
    Last Post: 08-16-2012, 12:35 AM
  3. what died?
    By Luc R in forum Buell Lightning XB12S, XB12Ss, CityX, XB12Scg
    Replies: 8
    Last Post: 06-30-2012, 11:13 PM
  4. *BUMP* for nice bike in Detroit
    By Fin in forum Buell Lightnings for Sale
    Replies: 2
    Last Post: 06-08-2011, 05:02 PM
  5. Bump start
    By Macbuell in forum Buell Lightning XB12S, XB12Ss, CityX, XB12Scg
    Replies: 12
    Last Post: 05-20-2010, 11:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •