firechickenXB9R,
Is this email address correct?
Can you email me a list with part numbers and price for your clutch and front spocket you have.
Thanks
www.natrlhigh80@yahoo.com
firechickenXB9R,
Is this email address correct?
Well sorry no "www." but everything else yes.
natrlhigh80@yahoo.com
Brembo 16mm Radial Front Master Cylinder from a '07 R1
ProTaper MX handle bar with Machined hand guard attachment plugs out of Delrin to fit the ProTaper bar and Bar end mirrors located at the OEM spot. I had to turn down the piece and thread to fit in the spot.
I modeled and CNC'd a Ducati Brembo Caliper adapter plate. Installed Ducati Brembo Two Piston Caliper. Installed Brembo Rear Master Cylinder.
The mod of switching over to the TWO PISTON BREMBO CALIPER delivers you ZERO increase in braking performance. It is only for cosmetics!
The Rear Master Cylinder needs to be replaced with a better one. Then it will work great.
PIAA Driving Lights, I like to ride at night in the summer. These lights allow me to keep sight of the line while in a turn.
PIAA Light Switch is on the left side, right above the low/high switch. The lights are wired with a relay switch that is energized when I switch the lights to high.
Hey did you notice a change when you put the clutch on and what was is?
Thanks
More initial grab
Hey point! What kind of mil;age have you done so far on this set up? I would think that aluminum will last less longer then the original.