This is what I do when I need to rotate the motor. Its just a few steps more than a rotate, but access to everything is hugely improved.
I know this is an old post but this is great! I just used this guide to do a top end on the Ulysses. Great write-up!
I bought one of those exhaust stud kits (not the one from above) and it didn't fit right. I had to pull the frame off just to get a straight shot at the stud because it was the top one on the back cylinder. But she has a fresh top end on her so I shouldn't have to do it again any time soon.
This is what I do when I need to rotate the motor. Its just a few steps more than a rotate, but access to everything is hugely improved.
I dont know about "helping". I think its just a gateway to get me into more trouble. Cooter. Shut. Up.
Why? Is the 34nineteens Buell junkyard growing?
So, this post was a tremendous help to me when I disassembled by xb12r. Amazing.
At the end of his initial instructions, Squidbuellie mentioned possibly putting togther instructions for reassembly. I know I can simply use this thread in reverse, but does anyone know if he made a thread for reassembly or if there is one floating around on this forum?
Thanks as always! Hoping to put my bike back together this weekend.