I have seen a lot of members asking how to remove their motors in the last few months.
So since I had some extra time I am going to do a dyi with pictures on how to remove your firebolt motor.
All in all it should only take you 1 to 1 1/2 hours from beginning to end.

Remove seat and battery


Remove the airbox


Remove the tank vent line


Remove the airbox base plate


Push the head breathers lines and velocity stack through the base plate then remove the air intake sensor


Remove the coil wire


Remove the O2 sensor


Remove the head temp switch


Take a screwdriver or needle nose pliers to remove the wire harness plug


Take apart the throttle housing and disconnect the throttle cables from the throttle tube


I just slide the throttle tube back on


Remove the throttle cables off of the throttle body with bent nose pliers


Remove the top motor mount


Remove the clutch cable from the clutch pirch