I'll let ya'll know tomorrow lol, will try to take some pics if I can find my ****ing camera...
you should only have to take out the drain plug i would assume. You shouldnt have to pull the four bolts unless you want to remove the pump.
I'll let ya'll know tomorrow lol, will try to take some pics if I can find my ****ing camera...
Are you having a hard time understanding? If so I can try to simplify it for you.
Unplug the fuel pump and start bike until it dies. Then hit starter button for 3-4 seconds to get the rest of the lines clear.
Then unscrew the drain plug.
look behind your left (shifter side) heal guard/footpeg at the base of the frame. should be a plate with wires and a hose going to it. then follow the diagram i made.
Yea I got the gist of it and located the plate. have to wait for light tomorrow to do it though.Thanks man.
No problemo !
Connector is a 13mm or 1/2 and the drain plug is the same. I think you are supposed to take the four allen screws out so you can pull the pump far enough from where it is on the bike to get a funnel under it and put the fluids in an epa approved container...**** that.
drill a whole in the frame and fill it with chewing gum afterwards :D
Already drained it out, of course, I found out that if you just turn the fuel pump on and off you can drain it like that, would just take forever.
wouldnt the tank drain with just the plug out?
It will, but you gotta drain the lines too...