, short, chasing, control, position, unplugged, front, turning, light, harness, entire, removed" /> Brake/horn fuse blows immediately
Results 1 to 5 of 5

Thread: Brake/horn fuse blows immediately

  1. #1
    Senior Member
    Join Date
    Dec 2011
    Posts
    358
    My brake/horn fuse blows immediately upon turning the key to the on position.
    I have unplugged the horn, front brake switch, rear brake switch, and rear tail light. I removed the left hand control box and entire associated harness. There was some rubbing on that but nothing through the insulation.

    Anybody have any tricks for chasing down a short? This is getting extremely frustrating

  2. #2
    I share your frustration. I keep popping the same fuse when I hit either brake. Still haven't got it fixed. One other unit on that circuit is the muffler control. Try unplugging it, too. I've got an '05 XB12Scg; the connection is by the left side of the battery. Good luck. Let me know what you find.

  3. #3
    Does this mean if I were to disconnect my horn my brake lights would not work?

  4. #4
    Senior Member mrlogix's Avatar
    Join Date
    Jul 2011
    Location
    Cincinnati, Ohio
    Posts
    2,561
    if either of you have a multimeter, go download the electrical diagrams off buellmods.com and use that to identify the circuit and the related connectors. Try pulling the relay for that circuit and see if it is still grounding out.

  5. #5
    Senior Member Chicknstripn's Avatar
    Join Date
    Aug 2014
    Location
    High Point, NC
    Posts
    2,143
    I'm with mrlogix. You guys need to check your relays. Switch them around and see if anything changes. If nothing changes then use a multimeter to determine which system is shorting out. Start with a good visual inspection of the wiring at the taillight. You'll have to remove your seat and the rear plastics to get a good view of everything. If you can't find something obviously wrong then use a multimeter and the service manual to trouble shoot where you're shorting out.
    madisonm55- the answer to your question is no. You can disconnect your horn and your brake lights should still work. And vise versa. However if you pull the brake/horn fuse both systems will stop working



Similar Threads

  1. right turn signal blows acc fuse
    By gtp3800 in forum Troubleshooting
    Replies: 6
    Last Post: 04-19-2014, 01:38 PM
  2. Key Switch Fuse - Mine Blows
    By Roger111R in forum Buell Firebolt XB12, XB9
    Replies: 2
    Last Post: 06-10-2013, 06:46 AM
  3. brake fuse blows, fuse box shorts?
    By flxbu31 in forum Troubleshooting
    Replies: 2
    Last Post: 05-01-2013, 05:28 PM
  4. blows ign fuse
    By salynch in forum Troubleshooting
    Replies: 0
    Last Post: 04-12-2012, 09:45 AM
  5. xb9 blows ignition switch fuse
    By cyaya in forum Troubleshooting
    Replies: 5
    Last Post: 07-29-2007, 08:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •