Results 1 to 2 of 2

Thread: Issue after ground came loose

  1. #1
    Senior Member
    Join Date
    Aug 2010
    Posts
    523
    I was riding home one day when the bike just died on me. Coasted to a stop and pulled off the seat. Turns out the ground bolt on battery had vibrated loose. Hand tightened it and went on my way. 1 min into riding and the bike stumbles/hesitates and check engine light comes on. Next day I go for a ride and it's doing the same thing. It'll stumble, check engine light comes on. After 10 mins of riding it'll run just fine but engine light is still on. Recently it got even worse. If I give it more than quarter throttle or above 3k rpms it stumbles. Any ideas?

  2. #2
    Senior Member
    Join Date
    Jun 2011
    Posts
    1,297
    Try a tps reset.. I do a tips reset about 2 times a month just to make sure its good.



Similar Threads

  1. 08 XB9SX VR/Ground issue
    By andrewlind87 in forum Troubleshooting
    Replies: 6
    Last Post: 05-31-2014, 11:37 PM
  2. Start / power issue. Battery?Ground?Idle?
    By Doctorfrogman in forum Troubleshooting
    Replies: 2
    Last Post: 10-14-2013, 08:46 PM
  3. Code 36 fan short to ground issue
    By egobuster1 in forum Troubleshooting
    Replies: 2
    Last Post: 09-04-2013, 02:42 AM
  4. Back end loose...
    By strider5656 in forum Troubleshooting
    Replies: 6
    Last Post: 07-05-2011, 01:22 PM
  5. Loose Ground
    By Ronin1 in forum Troubleshooting
    Replies: 0
    Last Post: 11-09-2009, 11:27 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •