How far apart are you taking it?
Going to install rocker box gaskets and intake seals. Any other suggestions while I have it apart?
How far apart are you taking it?
Just rotating engine to get to rear rockerbox and pulling off intakes.
You could clean your intake, it could have buildup.
I'm doing this same thing here in the next couple weeks to replace both rocker box gaskets and intake seals.
i decided to also do plugs and wire will I'm in there and some will suggest you can do pushrod O rings at the same time
to do pushrod orings you have to remove the head. that involves head gaskets and base gaskets. Maybe new piston rings if you pull the piston out of the cylinders. I would recommend leaving the head on unless it needs to be removed.
It is very convenient to change spark plugs though while you have the engine rotated.
I did get a set of push rod o rings cause I have a leak in the rear rocker base gasket. I read in a post I should change the top ones since i will be taking off the rocker box off the head. I also have symptoms of a intake leak so I'm going to put a set of James seals on the intakes.
I did get a set of push rod o rings cause I have a leak in the rear rocker base gasket. I read in a post I should change the top ones since i will be taking off the rocker box off the head. I also have symptoms of a intake leak so I'm going to put a set of James seals on the intakes.
Seems like a lot of leaks for 11k but I guess that's the price you pay for having a unique motorcycle hopefully the new and improved gaskets will do the trick.
im in the same both with the oil leaks and I'm at 7800 miles and i bought it with the leaks so who knows how long its been leaking already