None. Change your relay and any of the leds should work.
What aftermarket led signals work with the 1125 to give the correct flash rate.
None. Change your relay and any of the leds should work.
No relay goes thru the cluster. The 1125 comes with led's
There are none that I know of. Load resistors are always a possibility.
If you lose load resistors, put them somewhere that will get air. They can get hot as Hell.
I used oberon bar end leds and they work perfectly. Flash rate is unaffected. Leds come stock on the bike. Xblights led tail light is well worth the money too. I got the one with integrated turn signals.
It will really depend on the power output/consumption of the LED signal. Get the highest powered ones and you shouldn't have any problems. You almost always have to pay for quality though. It doesn't come with $25 for a set of 4 turn signals!
That's why independent rider ^^ doesn't have issues - Oberon + XBLights = YUMM!
Try and avoid load resistors if at all possible. I've seen them melt some ****.
I have leds on the rear turn signals and they act fine. I just plug and played. I integrated the front ones into the running lights. I will one buy some less for those if I don't sell this bike soon.