Results 1 to 4 of 4

Thread: XB12R to 88ci.

  1. #1
    Junior Member
    Join Date
    Mar 2019
    Posts
    1

    XB12R to 88ci.

    Hi,

    I have a 2004 XB12R and I've been dreaming about 88ci big bore kit.

    Can anyone tell me reasons, why I shouldn't do it? Does anyone have 88 kit in XB12?

    If I decide (read: get money) to start this kind of project, what else should I change?

    Thanks for answers and sorry, if my writing is hard to understand. I'm from scandinavia and my school years are far behind. 😁
    Last edited by Jupe666; 03-21-2019 at 05:59 PM. Reason: Typo

  2. #2
    Senior Member jl551c's Avatar
    Join Date
    Aug 2009
    Location
    Nipomo, Ca and Lake Luzerne, NY
    Posts
    714
    Your English is fine. I'm not at the level of expertise as some are on this website, but in my opinion the XB models have about as much horsepower and torque squeezed out of them as possible while still maintaining longevity and reliability. Unless maybe you're into drag racing it or something.
    Last edited by jl551c; 03-21-2019 at 06:36 PM. Reason: misspelled word

  3. #3
    Senior Member
    Join Date
    Mar 2015
    Location
    Phoenix, AZ
    Posts
    1,218
    If its your dream and money is not a barrier, go for it. Don't be surprised if the cost of the conversion, including tuning and all the extra parts is more than double what the bike is worth.

    If you want a fast Buell on the cheap, get an 1125R. It will run circles around your 88ci Firebolt.

  4. #4
    Senior Member Chicknstripn's Avatar
    Join Date
    Aug 2014
    Location
    High Point, NC
    Posts
    2,142
    Tuning will be your only issue
    Not much info out there on tuning big bore Buell(2003 and up models).

    If you do decide to mod... highly recommend converting to a 2008(or above) crank bearing and crank set up. 2004 to 2007 models have been known to have crank bearing issues. Some will protest that its not a known issue, however, I have experienced this failure. I also firmly believe the manufacturer would not arbitrarily convert bikes to a larger crank set up.

    Cost wise, you’re looking at about 3-4 thousand dollars(US), not sure of the conversion. I say that much because it would be pointless to do a big bore without modifying the heads, cams, fuel regular and fuel injectors.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •