Damn you are bored more than normal! I'm not sold on the new front fairing, but hey not my bike! Nice though!
When I first got her home
About 20 minutes later
Got some white fairings
Found a Firebolt fairing and some custom brackets
Added led headlights
Tried the Flexi Glass fairings They were ok
Added RFID Ignition
Added SOC fairings
Want to go back to a Cr front end(Parts are hard to find)
It's getting there......
Damn you are bored more than normal! I'm not sold on the new front fairing, but hey not my bike! Nice though!
Its temporary for now. Some day I'll be able to collect all the CR parts again. Not really much out there for that style. I found some PUIG ones that were cool, getting them is just as hard as CR parts
I really liked the firebolt front end. Any more pics of that setup?
Sorry..nope. Computer crashed a while back and I have very few pics of relevance left on my phone. I Kevin at KD Fab make the brackets so I didn't have to cut up the firebolt fairing stay. Its all bolt on. I wanted to keep it this way since I change stuff so often lol. I'll probably be getting rid of that set up in the future as well as the Flexiglass fairings. I got s far as test fitting those and ordering about $100 worth of camlock fasteners and good old ADHD took me in another direction.
recently got the part numbers for the front end of a CR and ran all the numbers by newcastlehd.com, minus all the hardware, the total was $380....headlight, windscreen, cluster surround plastic(dash board/ignition switch cover)...think I still have the list somewhere. the windscreen was about 70 bucks, the headlight is the most expensive of all the parts needed.Want to go back to a Cr front end(Parts are hard to find)
I say firebolt front end, SOC lower fairing and an ebr tail section. Buell parts.net sells the cr headlight for 181. I ordered one earlier this year because I'm trying to retrofit projectors into the stock cr housing.
Yeah I priced out the CR parts. Looking for some used stuff. I am a bit of a cheap bastard at times:D. A lighting or Ebr tail section would be cool. Has anyone done the mod yet? I purchased an aftermarket H4 led kit from RaceSport. I had to drill out the opening to accommodate the larger bulbs and trim the housing on the bulbs to make them fit. They seem a lot brighter than stock.
I have seen some photos of an 1125 with an ebr tail on it. Supposed to be a direct bolt on. The dual bi zenon projectors seemed like a good idea but even with the morimoto matchbox 2.0 I have had to dremel the whole headlight. Now I am in the fiberglass stage, don't think it was worth it.