Page 4 of 4 FirstFirst ... 234
Results 31 to 32 of 32

Thread: My xb12r front end hack

  1. #31
    Senior Member Chicknstripn's Avatar
    Join Date
    Aug 2014
    Location
    High Point, NC
    Posts
    2,144
    I did it a little ass backward since I don't have the right tools. I found my centers and drilled a pilot hole. Then I set my calipers to the radius I wanted. Using the pilot hole as my center I scribed a very fine circle around the pilot hole. Then I used my dremel tool with a metal cuting disk to cut the hole out. I tried to leave a little of the scribe line visible as I did my cut. Always better to leave too much material than the take too much off. Easier to remove material/metal than to add.
    I used a half round bastard file to finish the hole off.
    I don't know how much a quality hole saw/drill attachment cost but it would make cuting those holes a
    WHOLE lot easier!
    I usually do things the hard way. Gives me more of that quality me time in the garage

  2. #32
    Chicknstripn, I am thinking of doing this also. How did this turn out? WOW! 4 years later!



Page 4 of 4 FirstFirst ... 234

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •