Does the red stay on when the yellow flashes?
If the red can be separated in the middle the same way, I would put in 2 5 pin relays with a 87a terminal.
Thanks. Today I replaced the turn signal flasher and installed the LED flasher.
Disconnect the turn signal flasher and connect the LED flasher. They use the same socket.
The LED flasher does not have mounting bracket, so I use heavy duty double side adhesive to mount the new flasher
Tie the flasher using zip tie for safety
And now I can catch the turn signal moment on the camera
Does the red stay on when the yellow flashes?
If the red can be separated in the middle the same way, I would put in 2 5 pin relays with a 87a terminal.
My red stays on while yellow flashes as well - there is no point to mess about with this. It is clearly visible even from far away.
To b honest, I've noticed many genuine bikes with far worse rear light than this LED's.
There is no better looking tail light in the wide world.
Yes, the red stays on when the yellow flashes. I'm OK with it. You can use these Drugz Circuits for better contrast http://www.radiantz.com/en/products#...egory=10642190
I think this circuit is just a small transistor.
Last edited by TPEHAK; 09-11-2015 at 01:34 PM.
I took more better quality pictures with finished product
Nice forward foot pegs of cruising.
Amazing work!!
Incredible work !
thanks for overview. Was useful me ...)
my son recently 3D printed a tail section and looking to tweak the design some before entering the info into the Haas.