Results 1 to 2 of 2

Thread: crank lock tool

  1. 01-18-2016, 10:47 PM #1
    d_adams
    d_adams is offline
    Senior Member d_adams's Avatar
    Join Date
    Apr 2010
    Location
    Just outside of St. Louis
    Posts
    3,542

    crank lock tool

    Any interest in these? One on the left is the replacement, 4140 heat treated steel, will be all black oxide like the small end. This one was tested with a punch for hardness, then ran over with a scotchbrite wheel to clean it up after. $80/shipped each if you want one, these are NOT in stock, but I will have them made and start shipping them within a couple of weeks.

    https://squareup.com/market/dean-ada...k-locking-tool

    http://ecommerce.deanadamsdesigns.co...products_id=51

    crank lock pin.jpg
    Reply With Quote Reply With Quote
  2. 01-23-2016, 08:43 PM #2
    d_adams
    d_adams is offline
    Senior Member d_adams's Avatar
    Join Date
    Apr 2010
    Location
    Just outside of St. Louis
    Posts
    3,542
    Bump, I should have these back by mid-week.


    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules