Results 1 to 6 of 6

Thread: Parting out complete 2008 xb12 motor wiring harness and ecm

  1. #1
    Senior Member squidbuellie's Avatar
    Join Date
    Jan 2011
    Posts
    2,048

    Parting out complete 2008 xb12 motor wiring harness and ecm

    If you need some 08-up motor parts hit me up..... internals are good.... has bad cases motor has 4500 miles... Previous owner tried to remove primary chain to change the gearing to a xb9 thought the clutch was pressed on and used a puller and broke the lip on the case that holds the main bearing for the trans

  2. #2
    Senior Member squidbuellie's Avatar
    Join Date
    Jan 2011
    Posts
    2,048
    Bump

  3. #3
    Senior Member
    Join Date
    May 2016
    Location
    Central Soviet state of new jersey.
    Posts
    2,674
    I'm still learning about these bikes, so I have questions.

    The ECM will fit an 08 Ully ? If yes, is it stock ? Last, how much ?

    Thanks

  4. #4
    Do you have the oil pump housing?

  5. #5
    Junior Member
    Join Date
    Jun 2015
    Posts
    14
    Do you still have engine

  6. #6
    Senior Member squidbuellie's Avatar
    Join Date
    Jan 2011
    Posts
    2,048
    Yes, yes.... And the trans and heads are sold.

    All pm's answered.


    Last edited by squidbuellie; 12-08-2016 at 04:37 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •