Lol, you went balls to the wall. I bought an ironhead to build off this skinhead once and it had shell casings siliconed onto the primary cover bolts
bark buster screws are spikes too!!Sweet mother of God!.......lol
Lol, you went balls to the wall. I bought an ironhead to build off this skinhead once and it had shell casings siliconed onto the primary cover bolts
Besides spikes are one thing, williegoat's bike has a friggin mohawk! (which is awesome btw)
Wanted to follow up. I was able to order some stock well-nuts (and use the stock oem screws/washers).
In case searches in the future point to this thread, here are some thoughts:
1. Search evil bay for the well nuts vice ordering them direct...they are *much* less expensive than at your Harley shop. Use the item number in this thread for your search.
2. When installing, it will take *a lot* of compression on the "back" side of the nut to enable the stock screws to engage the threads. This increases the risk of cross-threading. The amount of force and compression necessary was surprising.
As far as the zero gravity, double-bubble windscreen goes:
1. Aesthetically it is nice, but not (imo) as "cool looking" as the stocker. It is a bit imposing with respect to the entire motorcycle.
2. Functionally it is superb - there is a noticeable change in wind buffeting at all speeds - especially if in a tuck on the freeway, etc.
Hope that helps.
Yeah - aesthetics are such a matter of personal taste. I like it on there...a lot. I *think* that from the perspective of the bike's lines, the stocker's profile matches it better (only in my opinion, of course).
Like I said, though, functionally the ZG screen is *quite a bit* better than the stock screen (again, in my opinion). :-)