Page 5 of 5 FirstFirst ... 345
Results 41 to 45 of 45

Thread: Anyone 08-09 using IDS ECU?

  1. #41
    Quote Originally Posted by Cooter View Post
    " IMO, ECMSpy and TunerPro were both built in mind of building fuel injection programs from scratch. If you have a turbo, cams, headwork, or all of the above, use one of those programs. ECMDroid is meant for diagnostics, datalogging and installing pre-existing tunes.
    However, you are able to "tune" your bike with ECMDroid using your Buelltooth bluetooth dongle by utilizing a O2 sensor (wideband), datalogging the info, and using the VE analyses section of MegaLog Viewer to build a fuel map with whatever target AFV's you wish."
    cool....what is the cleanest way to add the additional wire on the o2 sensor? Also, did my video come thru on the site? Had a hard time loading it for some reason...Thanks,

  2. #42
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    10,877
    Quote Originally Posted by mpkopish View Post
    cool....what is the cleanest way to add the additional wire on the o2 sensor?
    What? Why?

  3. #43
    Quote Originally Posted by Cooter View Post
    What? Why?
    The Narrow band o2 is one wire, and isnt the wideband o2 more than one wire?

  4. #44
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    10,877
    Yes. But you aren't buying a WB O2 and building the emulator circuit board from scratch.
    The single wire NB is simply the input wire to the ECM, The 3 wire WB sensor is for the pre-heater. 5V-signal-ground.

    You would be buying a WB O2 kit and using the stock O2 input to the ECM as both the datalogging record and the NB input when CL in enabled. No splicing needed.

    There is another open pin on the ECM for a separate pass-through but unnecessary for what you are doing.

  5. #45
    Quote Originally Posted by Cooter View Post
    Yes. But you aren't buying a WB O2 and building the emulator circuit board from scratch.
    The single wire NB is simply the input wire to the ECM, The 3 wire WB sensor is for the pre-heater. 5V-signal-ground.

    You would be buying a WB O2 kit and using the stock O2 input to the ECM as both the datalogging record and the NB input when CL in enabled. No splicing needed.

    There is another open pin on the ECM for a separate pass-through but unnecessary for what you are doing.
    ok, got it...Thanks,



Page 5 of 5 FirstFirst ... 345

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •