Page 1 of 2 12 LastLast
Results 1 to 10 of 11

Thread: pins behind detent plate broke off flush

  1. #1

    pins behind detent plate broke off flush

    Ok so I recently bought a 07 buell blast from family friend knowing it wouldn't shift ,thought just need the shift pawl adjusted, but come to find out ,two of the pins being the detent plate are snapped off flush and shifting the bike by hand it will only go into 1st and neutral ,I know I'll need to open the main case ,but is there a way to fix the broken pins ?

  2. #2
    Senior Member Chicknstripn's Avatar
    Join Date
    Aug 2014
    Location
    High Point, NC
    Posts
    2,144
    Did a quick Google search for ya.
    Check this out:
    http://buellridersonline.com/forum/s...ead.php?t=6827

    The above thread talks about adjust the shift drum pins so that they don't stick out too far. Don't know how you would reverse that adjust meant.
    Good luck

  3. #3
    Thanks but that I already searched And read though that

  4. #4
    Senior Member
    Join Date
    Jan 2009
    Location
    SF East Bay
    Posts
    1,136
    If the pins are broken off, treat them as any broken bolt and drill/extract them. Replace with new pins and then be on your way.

    No need to open the case.

  5. #5
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    8,048
    Hey Speed117, There's no need to start a bunch of new threads when it's the same subject on the same bike It will help everyone keep up to speed and give you better advise.

  6. #6
    Where do I get new pins jetlee ?

  7. #7
    Senior Member
    Join Date
    Jan 2009
    Location
    SF East Bay
    Posts
    1,136
    Check out the parts manual at http://BuellMods.com and then go to most any Harley dealer and order by part number. Never mention "Buell" or they usually refuse service.

  8. #8
    Jetlee I downloaded the manual But it doesn't have a part number for the pins

  9. #9
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    8,048
    Aren't they just regular hardened roll-pins? I doubt Buell proprietary engineered that part. Take the old ones out and measure. I bet your local hardware store has some.

  10. #10
    Nope no local shop has any around here this upset thanks Colter and jetlee y'all have actually been helpful



Page 1 of 2 12 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •