-
Member
ECMDROID TPS Reset
Forgive me if this has been posted somewhere else, but is there a step by step procedure somewhere for doing a TPS reset with ECMDROID? I've found plenty for ECMSpy, but I'm sure the process is a little different... ???
-
Member
Please help. Cannot get the bike to idle to save my life..
-
Open app, connect to Bluetooth dongle, go to active tests, click reset tps, it tells you to back out the idle adjustor so that the butterfly is closed, then it confirms you want to do the tps reset. After that you set the idle to right around 5 degrees and let the bike warm up (I ride for 10 or 15 minutes) and then come home and adjust the idle to around 1000 rpms (can adjust by the cluster and doesn't need hooked back up, although I usually do just to see the RPMs easier)
-
Once I get to a 03-07 bike, or finish my project bike, I'll make a video.
-
Member
How do I set the idle to 5 degrees?
-
Member
I thought I had it, but forget about letting the bike run to warm it up. It won't even stay running without constant throttle.
-
Member
I'm nearly certain I did this right. My mistake was making two changes at once. I changed the plugs before this reset, so now I don't know if the plugs or the reset is the problem.
-
Turn the idle adjustment knob until the tps reading is 5%
-
I believe ECMDroid calls it TPD throttle position degrees?
-
Member
OK... this is what I did... went to tps reset, backed off until 0... hit OK... went to data>tpd value, clicked live data on, turned back in until 5.5... started bike, wouldn't run right... then I did the same procedure and clicked tps reset again and OK after reaching 5.5, but before starting the bike... tried both ways again at 5.0 and 6.0... no dice...
I may have broken a plug wire? Would it run at all?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules