gear box noise

[DSHUMAKER]

Thanks John I already have the primary cover off and the shoe looks a bit worn. It has a nice set of grooves in it. I checked the primary cover over well and it looks to me that it just backed out.Oh Before I forget it's stuck in gear lol. I more than likely knocked the shift mechanism out of whack. So the clutch is 1-3/16 that I should be able to find. If anything this will be a good learning experience for me.

[DSHUMAKER]

Update today I finally had the time to pull the clutch off of the bike! I was able to get it out of gear and spin it through all the gears up and down smoothly! That's huge all in itself. I did notice the spacer between the housing bearing and clutch assembly looked a bit worn. The groves in it looks like it's seen some heat. The big gear on the clutch basket for the starter the teeth on the back edge were a bit chewed as well. I have an extra clutch setup. I'm going to get a new spacer and the install the extra clutch and see how it does as far as side to side play.