I have an 00 x1 cutting out bigtime under 3000 rpm at wot...does not like 4th gear roll-on on dyno at all.anyone have a race map that would work on it? i bought one on ebay, but i'm thinking its bogus. would like to compare the values.
Yeah. I am a noob with ECMspy. I have the cable now but need the software for a 2000. Is there an older format, or will the new one work on mine? Have gone to the sight and they have the latest download, just not sure if that's what I need..?
just a heads up, emcdroid wont work with any x1 ecm's only works for xb on-wards. but defiantly check the o2 sensor and injectors as these may be your issue
Incorrect. ECMDroid does work with certain tuber ECMs. As for which ones, I don't recall which ones worked, and which ones didn't.
sorry for the mis-infomation, was just going off what i was told by the local harley workshop. after trying to get it to work on my 02 x1 "race ecm, and a mates 99 x1 standard ecm..
I just purchased a 2000 X1 with the air intake and V&H exhaust and stock computer. It runs ok currently it has a check engine light on #14 temp sensor. I have a new one on order after that I assume I need to update the computer too. Right now if i let it idle for a min or 2 it loads up and I have to rev it up to clear it out. Not sure if that is the temp sensor or computer??
I have a similar issue on the s3 i just bought, its choppy in 1st at idle and wants to haul ass with just a little bit of twist, its got a full race exhaust from vance&hines from my understanding, also my check engine light popped on on day number 2 of ownjng it, runs fine but it idles a little higher in neutral when the light pops on vs when the lights off... any recommendations? Sorry to piggy back on someone elses post i cant seem to figure out how to start a new thread. My bikes a 2000 i bought it sunday
I would certainly suggest fixing it, before you get into any ECM fiddling.... IMHO.