-
Junior Member
09 XB12SCG Rough Idle/Stalling/backfiring when up to temp
I have a 2009 XB12SCG with EBR Race ECM with Jardine Exhaust
bike runs fine when it is initially started but will run like crap once it is up to temp. it almost sounds like a cyclinder drops out. bike runs fine when on the highway and only starts giving issues when in traffic (stop and go).
I have tried replacing the spark plugs but it did not help. I have also tried reinstalling the stock ECM but the bike will perform the same way. I have also tried doing a TPS reset which doesn't help aswell.
here is a couple vids of how it sounds
https://www.youtube.com/watch?v=FVVJ3Cy-OjE
https://www.youtube.com/watch?v=KWjaacQfT6Q
please help
thanks
-
-
-
Senior Member
I would say intake seals or 02 on it's way out. Your bike sounds like it is lean so could be either. Start with intake seals first easier to check.
-
Junior Member
checked the intake seals. they seem good. could it be the engine temp sensor? i'd hate to start just throwing parts at it.
-
Junior Member
Think I may have fixed the issue. I pulled and cleaned the IAC sensor ( there was a little bit of oil built up on tip not sure if that is normal?). also when I originally installed the jardine exhaust I unplugged the exhaust valve actuator and just left the connector under the cover so I decided to remount and plug it back in. are you suppose to remove it completely or leave it alone??. also did another TPS reset and IAT reset and drove the bike for 30-40 min. when i got home and let the bike idle for another few minutes with no issues
-
Senior Member
I'm assuming cleaning your IAC fixed the issues... The unplugged actuator should be a non-issue.
-
Junior Member
How did you clean your IAC?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules