Front Brake Disk 25th Anniversary 2009 1125R - will it fit a 2009-2010 Ulysses?

[Tango Nevada]

Question as the title, gentlemen. The previous owner fitted braided hoses, and the front brake is very good, but the front brake pulses at low speed, and it's annoying...

In fact, just to widen the net a little, are all the rim-mounted front brakes on all the XB12 models the same part number?

The rear brake is pretty poor, though. I assume that's normal?

[oh9bolt]

Yes it will fit, all XB's and 1125's use the same front and rear brake rotors

[Cooter]

Before you toss a good rotor, remember that improper bedding can cause that exact problem without being a warped rotor.

You could scuff the rotor and pads, bed them properly and see if that helps:
http://www.buellxb.com/forum/showthr...l-instructions

Also I highly recommend upgrading to the EBR mounting kit...

[Tango Nevada]

Thank you, guys. Cooter, the rotor on the bike at the moment has a pronounced wear lip on the outside, but none on the inside, so it's nearing the end of its life. Is the EBR mounting kit the one with part numbers CA0014.02A8, CB0006.02A8, H0505.02A8, H0506.02A8B?