New to me '06 Uly running rough

[GRONX]

About a month ago the bolts on mine had worked their way almost all of the way out. Luckily I noticed it and was able to hold it up while someone went and got me a wrench. I don't know the bolt size but good luck with the extraction!

[user_deleted]

Update:

With the Buelltooth and ECMDroid app, it was incredibly simple to retrieve the stored trouble codes. I did in fact have the #16 - Low Voltage code, but I also had a couple logs of #21 - ACM Stuck Open. I think I remember browsing a different thread where somebody disabled the interactive exhaust in the ECM. Is this advisable or not recommended? If not, what should I do to make sure the code doesn't come back?

NEW ISSUE: I parked at work this morning and noticed the bike was leaning a little lower than normal. Then she just started to fall and luckily I caught her before hitting the ground, right as the sidestand made a nice wind-chime sound on the blacktop. THE BOLTS SHEARED RIGHT OFF. So now I have a new after-work project of taking off the exhaust, extracting the broken bolts, and replacing. The manual doesn't specify the threads on the bolts. Does anyone know if these are 5/16"-18 or 8mm-1.25? I'm guessing it's safe to say all the fasteners on these bikes are standard, but I just want to be sure.

Thanks again for all of the help!

they are standard SAE.....not metric. also check your side-stand fastener. if it is the old style bolt and nut on back side replace with updated hardened pin and circlip. i have a few sets of them still in stock if needed.